Direction Control; Torque Control; Gear Selection - Westfalia A2S18 Originalanleitung

1. Open the chuck jaws (1) by rotating the chuck collar (2) anti-
clockwise.
2. Place the drill bit or accessory centrally into the chuck.
3. Tighten the chuck jaws by rotating the chuck collar clockwise.
4. When the drill bit or accessory is securely fastened, carefully run the
machine to test that it is running centrally, smoothly and evenly. If
the bit is 'wobbling' or not running centrally, release the chuck, check
the accessory for damage, correct its position, re-tighten and test
again.

Direction Control

WARNING: Never change the direction of rotation while the tool is
running. This may cause permanent damage to the tool.
 The direction of rotation can be set using the forward/reverse
switch (6).
1. For anti-clockwise rotation, push the switch to the right.
2. For clockwise rotation, push the switch to the left.
Note: When the forward/reverse switch is in the central position, the
tool is locked and cannot be switched on. Use this setting as a safety
feature to prevent the tool from being switched on accidentally.

Torque Control

The drill is equipped with a torque control clutch allowing the machine
to be set to the correct torque for the individual application.
The higher the number displayed on the torque selector (3), the higher
the torque produced by the tool.
If in doubt which torque setting best suits the application, start with a
low setting and increase, should more torque be required (e.g. if the
screw is not being driven far enough into the work-
piece).

Gear Selection

The cordless drill is equipped with 2 gears. The gear
switch is located on top of the cordless drill.
st
L = low = 1 gear
Operation
17