VESA Cynap Pure Montage

VESA ™ Mount (MIS-D 75mm / 100
The Cynap Pure is designed to be mounted onto a standard VESA™ mount
To mount the Cynap Pure onto a VESA mount (or back of the monitor), the interface plate needs to be fixed securely onto the mount in
the right orientation (note the arrow).
Alternatively, the interface plate can also be used to mount Cynap Pure onto a wall or similar. Select suitable screws and anchors,
when needed, to mount the plate securely.
Place Cynap Pure onto the interface plate until the fixing screw snaps into the slot and establish your cable connections.
To remove Cynap Pure from the mount, disconnect all cables and simply lift the device and pull it off.
Please note:
Consider heat output of 65 Watt!
Keep side area clear for fresh air ventilation.
Keep area at the back of Cynap Pure clear for cable connections.
Metal cabinets will decrease the possible range of wireless devices!
To select the screws, note the max. useable depth of thread.
Select the anchors and screws depending on wall surface.
VESA™ Mount or back of a Monitor
Attach the VESA bracket to the VESA mount or back of the
monitor by using the 4 mounting screws.
Attach the two black screws with the shaft to the bottom
chassis cover of Cynap Pure.
mm C - according VESA FDMI™)
Use the holes to suit
your mount or monitor.
□ □
75mm / 100mm
□ □
( 75mm / 100mm) .
included description
yes VESA Mount Plate
yes Snap-in screw (with shaft)
yes Mounting screw M4
no Screw, when needed
no Anchor, when needed
Wall or Furniture Mount
Attach the VESA bracked to the wall or furniture by using 4
screws and anchors, depending on wall surface.
Attach Cynap Pure to the correctly mounted VESA bracket.
To remove Cynap Pure, lift it up and pull it.
Printed in Austria - March 2019
qty.
1
2
4
4
4
www.wolfvision.com