Werbung
Verfügbare Sprachen
Verfügbare Sprachen
O P E R A T I N G I N S T R U C T I O N S
Quartz clock
Item no. 43 96 57 Step clock, clockwise rotation 11.3 mm
Item no. 43 96 83 Step clock, clockwise rotation 14.8 mm
Item no. 43 96 96 Step clock, clockwise rotation 16.8 mm
Item no. 43 97 10 Step clock, clockwise rotation 20.4 mm
Item no. 43 97 21 Step clock, clockwise rotation 23.8 mm
Item no. 43 97 22 Step clock, clockwise rotation 26.8 mm
Item no. 43 97 34 Step clock, anticlockwise rotation 11.3 mm
Item no. 43 97 35 Step clock, anticlockwise rotation 14.8 mm
Item no. 43 97 47 Step clock, anticlockwise rotation 16.8 mm
Item no. 43 97 60 Step clock, anticlockwise rotation 20.4 mm
Item no. 43 97 87 Sweep clock, clockwise rotation 14.8 mm
Intended use
The quartz clock is used to display the time.
To this end, a dial is installed and provided with suitable hands.
The watch may only be powered by a battery (for the type, refer to "Technical Data").
Any other use than the one described above may lead to damage to the product and involves other risks,
such as shorts, fi re, etc.
No part of the product may be modifi ed or rebuilt.
This product complies with the applicable national and European regulations. All names of companies and
products are the trademarks of the respective owners. All rights reserved.
The safety instructions have to be followed without fail.
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe these safety
instructions. We do not assume any liability for any resulting damage.
We shall not accept liability for damage to property or personal injury caused by incorrect
handling or non-compliance with the safety instructions. In such cases, the warranty will
be null and void.
In the operating manual, an exclamation mark inside a triangle indicates important instructions.
The "Hand" symbol indicates special tips and operating information.
• For safety reasons, any unauthorised conversion and/or modifi cation to the product is not permitted.
Never dismantle the product.
• The product is intended for use only in dry indoor locations. It must not get damp or wet.
• This product is not a toy and must be kept out of the reach of children. Only use the product out of
the reach of children. The product contains small parts and a battery that could be swallowed.
• Condensation may form when the product is brought from a cold room into a warm one. Therefore,
wait until it has reached room temperature before using it.
• Do not leave packaging material carelessly lying around, as it could become a dangerous plaything
for children.
• Do not expose the product to high temperatures, strong vibrations or heavy mechanical loads.
Batteries and Rechargeable Batteries
Batteries/rechargeable batteries must be kept out of the reach of children.
Do not leave batteries/rechargeable batteries lying around; they could be swallowed by children or pets. If
they are swallowed, consult a doctor immediately.
• Leaking or damaged normal / rechargeable batteries in contact with the skin can cause acid burns; there-
fore, use suitable safety gloves.
• Batteries/rechargeable batteries must not be short-circuited, opened or thrown into fi re. There is a risk of
explosion!
• Do not recharge normal, non-rechargeable batteries, risk of explosion! Only charge rechargeable batteries
that are intended for this purpose; use a suitable battery charger.
• Check that the polarity is correct when inserting the battery/rechargeable battery (pay attention to plus/+
and minus/-).
Installation
Please proceed in the following sequence:
1. Insert the suspension bracket, if necessary, to the hand shaft (required only for B/N 43 97 87).
2. Insert the supplied rubber washer to the hand shaft.
3. Insert the clock from the back through the hole in the dial and align it with the hanger horizontally
from above.
4. Place the shim on the hand shaft and screw the clock in place using the central hexagon nut.
Do not tighten the nut too tightly to avoid distortion and damage.
5. Insert the hour hand fi rst and then the minute hand gently to the hand shaft and secure the minute hand
using the small knurled nut. If a second hand is used, the cap nut can be used to cover the hand shaft.
For B/N 43 97 87, the minute hand must not be secured.
6. Finally insert the second hand into the hand shaft, if used.
7. Align all the hands of the clock to the 12:00 o'clock position.
www.conrad.com
8. Make sure that the hands are aligned parallel to the dial, so that you cannot touch or drag on the dial
during subsequent operation.
Version 05/13
Inserting the Battery/Rechargeable Battery
• Insert a battery of the 1.5V AA/Mignon type into the battery compartment on the back of the case. The
correct polarity is indicated in the battery compartment.
• Replacing the battery is necessary when the clock stops or the accuracy of movement decreases.
Setting the time
Set the time by turning the adjustment knob with the clock symbol on the back of the case. The adjustment
knob can be rotated in both directions here.
Maintenance and Cleaning
To clean the clock, a dry, soft and clean cloth or a brush is suffi cient. Do not use any chemical cleaning
agents, as they can discolour the plastic case.
Disposal
a) Product
b) Normal and Rechargeable Batteries
You thereby fulfi l your statutory obligations and contribute to the protection of the environment.
Technical Data
a) Battery data
Type .................................... 1.5 V/DC (AA/mignon battery)
Battery life ...........................approx. 1.5 to 2 years
b) Mechanical data
Order
no.
43 96 57
43 96 83
43 96 96
43 97 10
43 97 21
43 97 22
43 97 34
43 97 35
43 97 47
43 97 60
43 97 87
The minute and second hands should not exceed the following dimensions and weights:
Minute hand: max. 160 mm / 6 g
Second hand: max. 130 mm / 6g
A rechargeable battery may be used, but due to the lower voltage output (rechargeable battery
= 1.2V, standard battery = 1.5V) and the lower capacity, the service life is shorter.
Electronic devices are recyclable waste materials and must not be disposed of in the household
waste!
Dispose of an unserviceable product in accordance with the relevant statutory regulations.
Remove the battery if there is one inserted and dispose of it separately from the product.
As the end user, you are required by law (Battery Ordinance) to return all used batteries/re-
chargeable batteries; disposal of them in the household waste is prohibited.
Batteries / rechargeable batteries containing harmful substances are marked with the follow-
ing symbols, to indicate that disposal in the domestic waste is forbidden. The symbols of the
relevant heavy metals are: Cd = Cadmium, Hg = Mercury, Pb = Lead. You can return your used
batteries/rechargeable batteries free of charge to the offi cial collection points in your municipal-
ity, in our stores, or anywhere where batteries or rechargeable batteries are sold.
Shaft (mm)
Hand hole
Dial thickness (mm)
(mm)
11.3
2.8 x 3.8 / 5
2.5 to 3
Round slotted
hole
14.8
2.8 x 3.8 / 5
max. 3
Round slotted
hole
16.8
2.8 x 3.8 / 5
max. 5
Round slotted
hole
20.4
2.8 x 3.8 / 5
max. 9
Round slotted
hole
23.8
2.8 x 3.8 / 5
max. 12
Round slotted
hole
26.8
2.8 x 3.8 / 5
max. 15
Round slotted
hole
11.3
2.8 x 3.8 / 5
2.5 to 3
Round slotted
hole
14.8
2.8 x 3.8 / 5
max. 3
Round slotted
hole
16.8
2.8 x 3.8 / 5
max. 5
Round slotted
hole
20.4
2.8 x 3.8 / 5
max. 9
Round slotted
hole
14.8
3.3 / 5.1
max. 3
round / round
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfi lming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2013 by Conrad Electronic SE.
Mounting
Direction
hole (mm)
of
rotation
10
right
8
right
8
right
8
right
8
right
8
right
10
left
8
left
8
left
8
left
8
right
Werbung
