Getting Started; Operation - Bestway 58624 Bedienungsanleitung

GETTING STARTED

IMPORTANT NOTE: Fully charge the electric vacuum before using it for the first time.
Charging the battery
NOTE: It requires an USB charging adaptor (not provided) with a safety output of 5.0V DC and 1.0A.
For EU market, a CE-certificated USB charging adaptor shall be used.
WARNING!
• Do not use the USB charging cable / USB charging adaptor if any damage is detected.
• Make sure both the electric vacuum and the charging port are clean and dry before charging them.
• Refer to the instruction manual of USB charging adaptor (not included) for instructions concerning safety and operation.
1. Place the unit on a flat surface. Turn the switching knob anticlockwise until it stops and completely exposes the charging port. Align and insert
the USB charging cable into the charging port.
2. Connect the USB charging cable to the charging adaptor, then plug the charging adaptor to the power source.
NOTE
• Charge the electric vacuum completely (about 7-8 hours) before using it for the first time.
• Always disconnect the USB charging adaptor from the power source as soon as charging is complete.
• Immediately turn the power off and disconnect the USB charging adaptor from the power source if you detect any of the following conditions:
- Offensive or unusual odor
- Excessive heat
- Deformation, cracks, leaks
- Smoke
1. Connect the USB charging adaptor to the power source. Once the electric vacuum begins charging, the indicator light at the end of the vacuum
will turn red. Normally, it takes about 4.5 - 6 hours to reach a full charge. The indicator light will turn green once the electric vacuum is almost
fully charged.
2. When charging is complete, disconnect the charging adaptor from the power source and unplug the USB cable from the adaptor and electric
vacuum.
Normally, the electric vacuum can operate up to 40 minutes on a full charge (after 4.5-6 hours of charging)
Note: Clean the filter regularly. Excessive debris inside the filter will increase burden to the motor operation and shorten the operating duration as a
result.
NOTE: Rechargeable lithium-ion battery is classified as a consumable item. It has a limited life and will gradually lose its capacity to hold a charge.
Therefore, the running time of the electric vacuum will gradually reduce after repeated charging and discharging throughout its product life.
NOTE: Let the electric vacuum rest for 30 to 40 minutes before charging it again.

OPERATION

Before immersing the electric vacuum in water, turn the switching knob clockwise until it comes to a halt (you will
hear a 'click") to expose the two water-sensing pins and a green dot on the right side. As soon as both pins make
contact with water, the motor will start running. Similarly, it will stop as soon as the pins are no longer in contact with
water.
NOTE: Never attempt to make contact with both pins with anything other than clean water.
CAUTION
• DO NOT cover the side slot (middle gap) of the electric vacuum during operation, the impeller / motor may be damaged otherwise.
• Remove the electric vacuum from the pool/spa as soon as cleaning is complete.
CAUTION! Make sure the electric vacuum is always pointing downwards when it is placed into the pool. Otherwise, the pole connector may be bent and
damaged as a result.
To retrieve the electric vacuum from the pool / spa, lift the electric vacuum while pointing it downwards in order to allow water to discharge.
Rinse the electric vacuum with fresh water after every use. DO NOT use any detergent.
EMPTYING THE FILTER
WARNING! Using the electric vacuum without a filter bag / filter cage in place
will VOID your warranty.
In order to maximize the cleaning efficiency of the cleaner, be sure to clean the filter
bag/ filter cage before and after each use.
CAUTION! If the electric vacuum is charging, disconnect the USB charging adaptor
from the power source and detach the electric vacuum from the USB charging cable
before making any attempts to clean it.
Emptying filter bag / filter cage
1. Place the electric vacuum on a stable surface.
2. Hold the electric vacuum body and turn the canopy anticlockwise until the white
marking on the canopy reaches the lock-unlock marking. (Fig.1) Detach the
canopy and remove the filter bag / filter cage from the electric vacuum
6
Fig.1