AHCON PCI 900 Betriebsanleitung Seite 4

Warnings
Be Careful! Tire inflation can be dangerous.
Use only trained personnel to perform tyre service.
AHCON PCI 900 must be used by trained personnel only.
AHCON PCI 900 must be used for inflation of motorcycles, passenger car wheels, van and
truck wheels, as wells as agricultural and industrial wheels only.
Inflating smaller wheels or toys, for instance; bicycle wheels, wheelbarrows, child
equipment wheels, child toys, footballs or any other kind of toys, is not allowed.
The equipment MUST be supplied with clean, dry air from a compressor air system / line.
Maximum supply air pressure for the 7 bar model is: 10 bar.
Maximum supply air pressure for the 12 bar model is: 14 bar.
AHCON disclaim all responsibility for failures occurring from working procedures, which do
not comply with procedures recommended by AHCON and / or tyre and rim
manufacturer's recommendations (ETRTO / STRO).
Risks and Labelling
Max. Inlet pressure for the 7 bar version is 10 bar.
Max. Inlet pressure for the 12 bar version is 14 bar.
The PCI 900 - 12 bar version may be used ONLY as a part of an AHCON Safety
Inflation Cage.
If this equipment is exposed to higher inlet pressure than specified, it may result in
equipment damage with the risk of explosions due to over-inflating.
Attention: Risk of personnel injury and equipment damage.
4