Operation Shaking; Assembly Of Accessories; Anti-Condensation Plate Ba 24 / 96 - HLC l MHR 11 – TH 21 Bedienungsanleitung

Displayed
remaining
time:

Operation Shaking

For shaking, the mains switch on the
back of the system must be switched
on.
With the scaled slider, the shaking
frequency can be set to a value
between 0 and 1.500 rpm in steps of 250. For fine-tuning, in steps of 10, use
– + .
the keys and
display for three seconds. The recommended min. rotational speed is 80 rpm,
lower rotational speeds can also be set.
Please note that the HeatingThermo Shaker MHR 11 will shake immediately if
the shaking frequency is set, independent of the start of the tempering.
If the rotational speed is to be displayed during a running process, decrease or
increase the rotational speed with + and – by 10 rotations, the current rota-
tional speed value is then displayed for three seconds.

Assembly of Accessories

Anti-condensation plate BA 24 / 96

The anti-condensation plate BA 96 (800013000) is placed on the attached
block, no assembly steps are required. For using the anti-condensation plate
The currently entered rotational speed is indicated on the
The time remaining until the end of
the process is indicated on the dis-
play with flashing "
OK
for 10 seconds and releasing the
button, you get back to the temper-
ature display.
10
: .
"
By pushing