Operation; Switching On The Appliance; Basic Setting Of The Appliance; Close Operation Of The Appliance - BOMANN EK 6024 CB Bedienungsanleitung, Garantie

Operation

CAUTION:
Do not switch on the appliance until it has been properly
installed!
NOTE:
• The operation can partly be done via the control panel
of the appliance.
• To set the timer programming, use the remote control.
• Each operating step will be acknowledged by a signal
tone.
• After switching on the appliance, the display behind the
glass front becomes visible. For a better ambience, the
display will switch off approx. 30 seconds after each
operation. Press any button to reveal the display again.

Switching on the Appliance

Set the power switch to position I. The appliance is in
Standby. The symbol lights up in the display.

Basic Setting of the Appliance

After switching on the appliance via the power switch, it will
be in the following basic setting:
- Weekday = SUN (Sunday)
- Display of the current room temperature
- Time =
- Intensity of the flames
- Heating = off
- Timer = off with first operation / check activation in
further operation
NOTE:
• Even in the event of a power failure, the appliance is
reset to this basic setting.
• For safety reasons, the appliance will always start
without heating.

Close Operation of the Appliance

- Switching on the electric built-in fire
You can switch on the appliance on the control panel by
briefly pressing the button. The basic setting of the appli-
ance will become visible in the display.
­ Setting system time
Press this button to set the current time and day of the
week. Use the and buttons to set the weekdays. Press
the button again to set the hours. The minutes can be set by
pressing the button again.
­ Setting the brightness levels
Push this button to set various brightness levels. The stair
display H on the display shows the currently set step.
= high
­ Setting the heating levels
Push this button to set the heating levels. The symbols F on
the display show the currently set heating level.
1 LED = heating level 1 (900 W)
2 LEDs = heating level 2 (1850 W)
No LED = The appliance heating function is switched off.
The fan continues to run for 10 seconds.
NOTE:
The heater and the fan will not be switched on by the ap-
pliance until the room temperature is lower than the base
temperature for the heater (see basic setting).

Operate of the Appliance from the Distance

- Switching on the electric built-in fire
You can switch on the appliance on the control panel by
briefly pressing the button. The basic setting of the appli-
ance will become visible in the display.
­ Setting the day
Press this button to start the weekday setting. Use the
and buttons to set the weekdays.
­ Setting hours
After pressing this button, you can set the hours with
and .
­ Setting minutes
After pressing this button, you can set the minutes with
and .
­ Setting the timer
Press this button to enter the weekly timer setting mode
and follow the descriptions under "The Timer".
­ SET UP
Press this button to switch between the switch-on and
switch-off times. The display shows the selection with the
symbols D and E. See "The Timer".
­ Setting the brightness levels
Push this button to set various brightness levels. The stair
display H on the display shows the currently set step.
­ Setting the heating levels
Push this button to set the 2 heating levels.
Press once = 900 W, press twice = 1850 W.
To set the temperature during heating, press the or
buttons. The adjustable temperature range is between
15 and 30°C.
21