Werbung
Verfügbare Sprachen
Verfügbare Sprachen
O P E R A T I N G I N S T R U C T I O N S
Weather Protection Housing
for TLC200
Item no. 55 33 37
Intended use
The weather protection housing enables the use of the TLC200 time lapse camera outdoors
in all weather. Even in a storm, the time lapse camera is well protected, which also enables
recording at any time of year and at any location. The weather protection housing protects your
time lapse camera from damage from dirt, rain or sand.
Any use other than that described above is not permitted and can damage the product.
This product complies with the applicable national and European regulations.
All names of companies and products are the trademarks of the respective owners.
All rights reserved.
The safety instructions have to be followed without fail.
In the operating manual, an exclamation mark inside a triangle indicates
important instructions.
The "hand" symbol indicates special information and advice on operating the
device.
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe
these safety instructions! We do not assume any liability for damage to prop-
erty and injury to persons caused by mishandling or non-compliance with the
safety instructions! In such cases, the warranty will be null and void.
General safety instructions
• For safety and approval (CE) reasons, unauthorised conversion and/or modifi ca-
tion of the product are not permitted.
• Do not expose the product to high temperatures, strong vibrations or heavy
mechanical loads.
• Handle the product with care; it may be damaged by impacts, blows, or accidental
falls, even from a low height.
• If you have any doubts about the correct operation, or the safety of the product,
please consult a specialist.
• This product is not a toy and must be kept out of the reach of children. Only use the
product out of the reach of children. Small parts of the product could be swallowed.
• Do not leave packaging materials unattended. It may become a dangerous
plaything for children.
• Also observe any further safety instructions in the individual sections of this
operating guide.
Controls and Parts
(1) Latch closures
(2) Connection for accessories (remote release, PIR sensor)
(3) Connection for the Micro-USB cable
(4) Rubber seal
(5) "MENU" button
(6) "TIME" button
(7) "OK / START" button
(8) Storage space for rubber cover for the TLC200 camera
Preparing the TLC200 time lapse camera
www.conrad.com
• Switch on the time of the TLC200 time lapse camera at the "OK / START" knob
• Point the lens of the time lapse camera directly
Version 07/13
forward
• Place the time lapse camera in the weather protection housing and make sure that the water-
proof rubber seal (4) is correctly inserted
Function of the weather protection housing
• Close the fl ap of the weather protection housing and lock the closures (1) above and below
by hanging the wire bracket on the hook of the fl ap and then pressing the closure downward
• Set the time interval for image capture and press the "OK / START" button (7) to start
• On the exterior, there is a watertight rubber closure for connecting accessories (remote
release, PIR sensor) (2) and the Micro-USB cable (3) to the time lapse camera from the
outside
• You can also operate the time lapse camera from outside the weather protection housing with
the "MENU" (5) and "TIME" (6) buttons
• On the underside of the weather protection housing, there is a thread for attaching a tripod
Maintenance and Care
This device is maintenance-free. Only clean the exterior with a soft, dry cloth or a brush.
Never use caustic cleaning agents or chemical solutions, as they could damage the surface
of the casing.
Disposal
Device
Technical Data
Material of housing ...................................................... PC
Material of front lens cut-out ........................................ Acrylic
Material of buttons and connection covers .................. Rubber
Water-tightness............................................................ IPX 4
Dimensions .................................................................. 127 x 90 x 55 mm
Weight ......................................................................... 118.7 g
Declaration of Conformity
We, Conrad Electronic, Klaus-Conrad-Straße 1, 92240 Hirschau, hereby declare that this
product adheres to the fundamental requirements and the other relevant regulations of
Directive 1999/5/EC.
Check again to make sure that the door is closed and watertight
Dispose of an unserviceable product in accordance with the relevant statutory
regulations.
The Declaration of Conformity for this product can be found at www.conrad.com
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfi lming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2013 by Conrad Electronic SE.
Werbung
