Setting The Clock; Microwave Cooking - eta 1210 Bedienungsanleitung

GB
– If MW oven does not work properly, disconnect it from electrical socket, wait 10 seconds,
and then re-connect it.
– If the appliance is running, the interior will be lighted.
– The door may be opened during the cooking process. The timer shall stop and the
appliance operation will be interrupted. To continue, press "Z".
– After the preset time of the selected function/programme expires, a sound signal will be
heard, and the appliance will switch to standby mode.
– The rotary plate may rotate in any direction.
– If the door opens in standby mode or during the setting process, the introductory information
on the display will remain the same. It may be changed and set, but "Z" button will not work.

1. SETTING THE CLOCK

Once the oven is connected to the electrical mains, "1:01" will appear on the display, and
an acoustic signal will sound. Then the appliance shall switch to idle.
1) Press "H" in standby mode.
displayed. Press again to select 24 H time format.
2) Set the current hour by rotating "K" knob.
3) Confirm by pressing "H" – minute digits shall start blinking.
4) Set minutes in the interval 0-59 by rotating "K" knob.
5) Press "H" to finish. ":" will start blinking.
– If you press "H" while cooking, current time will be displayed for a moment.
– If you press "ST" button during setting the clock, the oven shall automatically return
to the previous mode.
– To change the clock setting, please apply the same procedure.
2. FAST COOKING
a) Press "Z" button in idle condition of the oven to start food cooking with full microwave
output for 30 seconds. Each subsequent pressing of "Z" button will extend the cooking time
by 30 seconds.
b) In idle condition, select the cooking time by rotating "K" to the right, and confirm by
pressing "Z" button to start cooking with 100 % output.

3. MICROWAVE COOKING

1) Use "W" to select the microwave output (5 levels are available for setting – see the table
below).
2) Set the preparation time by rotating "K" button.
3) Press "Z" to start cooking.
The number of times
"W" is pressed
Microwave power
Information displayed
Notes
starts flashing and time format selection 12 H will be
Notes
1 2
100 % 80 %
1S
40 / 85
3 4
60 % 40 %
1S
5
20 %