Fluval UVC IN-LINE CLARIFIER Handbuch Seite 4

12. To avoid the possibility of the appliance plug getting wet, position the tank to the side of a wall
mounted receptacle to prevent water from dripping onto the receptacle. A "drip loop", should be arranged
by the user for each cord connecting an aquarium device to the receptacle. The "drip loop" is the part of
the cord below the level of the receptacle or the connector if an extension cord is in use, to prevent the
water from travelling along the cord and coming into contact with the receptacle. If plug or receptacle
gets wet, DO NOT unplug the cord. Disconnect the fuse or circuit breaker that supplies power to
the receptacle then unplug the transformer and examine for the presence of water in the receptacle.
13. This appliance contains a UVC emitter. Unintended use of the appliance or damage to the housing area may result in
radiation. Exposure, even in small doses, may cause harm to eyes and skin. Damaged units should not be in operation.
WARNING –
14. Disconnect all appliances when performing maintenance.
15. The appliance is to be supplied through a residual current device (RCD) having a rated residual operating current
not exceeding 30 mA.
16. Do not use the appliance for any purpose other than that for which it is intended. The use of attachments not
recommended or sold by the appliance manufacturer may cause an unsafe condition.
• Do not use this product in swimming pools or other situations where people are immersed.
• This product is suitable for use with water temperatures up to 35 °C.
• Do not use this product with inflammable or drinkable liquids.
• To avoid overheating, always ensure the filter is pumping water through the unit while the UVC is plugged in.
• This product should not be placed where it can fall into the water. It should be placed in a dry and protected place,
with sufficient ventilation around it.
17. If an extension cord is necessary, ensure connection is watertight and dust proof. A cord with proper rating should be used.
A cord rated for less amperes or watts than the appliance rating may overheat. Care should be taken to arrange the cord
so that it will not be tripped over or pulled. The connection should be carried out by a qualified electrical installer.
WARNING
Do not connect power to unit unless unit is fully and correctly assembled. The unit must always be
–
fully filled with water when operating.
18. Do not cut hose.
SAVE THESE INSTRUCTIONS
19.
PREPARING YOUR FILTER (EXISTING SETUP)
1. Ensure your canister filter is unplugged.
2. Ensure your canister and its hoses are empty of water and the hoses are removed from the aquarium before beginning
UVC unit installation.
UVC INSTALLATION
The UVC unit is compatible with Fluval 06 and 07 series canister filters, in addition to those with output hose inner diameter of 5/8"
(16 mm) and an outer hose diameter of 1/8" (19 mm).
1. Insert ribbed hosing supplied with your UVC unit into the output nozzle of your canister filter and tighten nut.
2. Connect other end of UVC supplied hosing into one side of UVC unit and tighten nut.
NOTE: The UVC unit is multidirectional and will operate in either direction.
3. Connect filter output hosing to the opposite (unused) UVC nozzle and tighten nut.
4. To ensure maximum flow, DO NOT install UVC unit above the aquarium water line. To make sure the output hose
reaches the aquarium with no kinks or loops, trial mount the UVC unit and hose before making any final cuts or holes.
NOTE: The UVC unit is supplied with (2) mounting screws for easy installation.
5. Attach filter output and intake assembly to aquarium (Refer to filter manual for proper installation).
6. Prime your canister filter.
7. Plug in your canister filter to electrical outlet and ensure that water is flowing in and out of the canister filter.
8. Plug in the UVC unit to electrical outlet.
1
2
3
Aquarium Output
4
4
2
3
1
5