General Information - Grundfos GT-U+ Montage- Und Betriebsanleitung

English (GB) Installation and operating instructions
Original installation and operating instructions
These installation and operating instructions
describe Grundfos GT-U+.
Sections 1-5 give the information necessary to be
able to unpack, install and start up the product in a
safe way.
Sections 6-10 give important information about the
product, as well as information on service, fault
finding and disposal of the product.
CONTENTS
1.

General information

1.1 Hazard statements
1.2 Notes
2. Receiving the product
2.1 Inspecting the product
3. Installing the product
3.1 Location
3.2 Mechanical installation
3.3 Multiple tank installation
4. Starting up the product
4.1 Precharge pressure
4.2 Adjusting the precharge pressure
5. Handling and storing the product
5.1 Handling the product
5.2 Storing the product
6. Product introduction
6.1 Intended use
6.2 Pumped liquids
6.3 Identification
7. Servicing the product
7.1 Maintaining the product
8. Fault finding the product
9. Technical data
10. Disposing of the product
Read this document before installing the
product. Installation and operation must
comply with local regulations and accepted
codes of good practice.
1. General information
1.1 Hazard statements
The symbols and hazard statements below may
appear in Grundfos installation and operating
instructions, safety instructions and service
Page
instructions.
5
DANGER
5
Indicates a hazardous situation which, if
6
not avoided, will result in death or serious
6
personal injury.
6
WARNING
6
6
Indicates a hazardous situation which, if
6
not avoided, could result in death or
7 serious personal injury.
7
CAUTION
7
Indicates a hazardous situation which, if
8
not avoided, could result in minor or
8
moderate personal injury.
8
The hazard statements are structured in the
8
following way:
8
8
SIGNAL WORD
8
Description of hazard
9
Consequence of ignoring the warning.
- Action to avoid the hazard.
9
9
1
0
1
0
1
0
5