habitat et jardin Eco 1436 103290 Installations- Und Benutzerhandbuch Seite 31

B. Installation instruction
1) Location and size
The heat pump should be installed in a place with good ventilation
* MINIMUM DISTANCE
Filter
Water processor
Water switch
2) The frame must be fixed by bolts (M10) to concrete foundation or brackets. The concrete
foundation must be solid and fastened; the bracket must be strong enough antirust treated;
3) Please don't stack substances that will block air flow near inlet or outlet area, and there is
no barrier within 50cm behind the main machine, or the efficiency of the heater will be
reduced or even stopped;
4) The machine needs an appended pump (Supplied by the user). The recommended pump
specification-flux: refer to Technical Parameter, Max. lift ≥10m;
5) When the machine is running, there will be condensation water discharged from the
bottom, please pay attention to it. Please hold the drainage nozzle (accessory) into the hole
and clip it well, and then connect a pipe to drain the condensation water out.
8