Operation And Handling - zelmotor professional 610 Gebrauchsanleitung

B

Operation and handling

Clean the products intended for drying and
distribute them on the sieves making space
between them, so that the airflow through the
sieves was not cut out.
.
Put the sieves with the products on heat-and-ventila-
tion unit and cover them with the lid.
.
Switch the dryer on.
1. Half-power – press the master switch button "POWER",
the dryer shall be on in half-power mode (225W) and the
control light of master switch shall go on (B).
2. Full power – press the switch button II "FULL POWER",
the dryer shall be on in full power mode (450W) and the
control light of II switch shall go on (C).
3. Back to half power – press the switch button II "FULL
POWER" again, and the full power shall be off, the switch
control light shall go off (C), the dryer operates in half-power
mode then (225W).
.
Switch the dryer off after product drying.
3
C
A
4. If the dryer operates in half-power mode (225W) press
the master switch button „POWER". The dryer shall switch
off and the control light of master switch shall go off (B).
5. If the dryer operates in full power mode (450W) press the
master switch button „POWER". The dryer shall switch off
and both control lights shall go off (B and C).
i
Heated air flows through the sieves evaporat-
ing water out of the products being dried. The
time of drying depends on the content of water
inside the products and their thickness, i.e. we recom-
mend to dry not thicker slices of apples than 5 mm.
i
It is recommended to change the sieves
positions from time to time during drying, to
obtain equal products drying. Drying watery
products, such as: plums, grapes of wet mushrooms
needs much more time.
D
2
1
str. 6