ICS Schneider Messtechnik P 700 T Betriebsanleitung Seite 27

P 700 T
Qualified personnel:
The personnel who are charged for the installation and operation of the P 700 T must hold
a relevant qualification. This can be based on training or relevant tuition.
The personnel must be aware of this operating manual and have access to it at all times.
General safety instructions:
In all work, the existing national regulations for accident prevention and safety in the
workplace must be complied with. Any internal regulations of the operator must also be
complied with, even if these are not mentioned in this manual.
Never use the P 700 T together with an external pressure source. Do not connect an ex-
ternal pressure generator to the P 700 T.
Do not use brake liquid or other aggressive media.
Hydraulic oils may cause irritation in case of skin contact.
 Take suitable protective measures to avoid skin contact.
 Observe the manufacturer's operating manual or the safety data sheet.
Do not remove any connected components (test sample, pressure hose, reference) if the
P 700 T is under pressure:
 Open the pressure relief valve before removing any of the components.
Do not use Teflon tape to seal the pressure connections. Surplus Teflon tape can enter
the P 700 T and damage it.
 Only use adapters and seals that are available as accessories.
Non-pressurised storage: Only store the P 700 T with the pressure relief valve open. This
ensures that no pressure can be built up by unintentional pumping movements.
Avoid external force of all kinds towards the P 700 T and its operating elements.
Do not use the P 700 T if it is damaged or defective.
Special safety instructions:
Warnings that are specifically relevant to individual operating procedures or activities can be
found at the beginning of the relevant sections of this operating manual.
Technical changes reserved
Safety instructions
- 27 -