Inhaltsverzeichnis
Werbung
mer service point.
- Always take note of the general safety rules when using electrical equipment.
Maintenance/cleaning notes
- Before carrying out any cleaning or maintenance work, remove the plug or switch off the
electrical equipment!
- Clean the surface of the housing and the guard with a dry cleaning cloth and a damp brush.
- Do not use petrol or any similar light flammable cleaning material.
Storage
- If the fan is not to be used for some time, then store it in a dry room.
- In addiion, you could put a cover on your unit to protect it from dust or dirt deposits.
Disposal
- Remove mains plug
- Cut through the mains cable at the plug
- Dispose of the unit in a proper manner.
Help with faults
Problem
The heater does not work.
If the above information does not fix the problem, unplug the heater by removing the
plug from the wall socket.
In the case of a damage or breakdown, please leave the heater with a qualified electri-
cian to fix the problem.
If the power cord on the unit is damaged it may only be replaced by a repair facility
authorised by the manufacturer. Replacement of the power cord requires special tools.
Attention: Any repairs including replacing the halogen heating lamp should only be
carried out by a qualified electrician or by a recommended service center!
Suggestions for rectification
1-
Check main and ancillary fuses. It should
be an non-fast acting fuse dimensioned
for the maximum power of your heater.
2-
Check heater for correct connection to the
power socket.
3-
Check the both switch settings (Standby
and On/Off) at the heater.
GB
13
Werbung
Inhaltsverzeichnis
