Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4
Installation
Mount the unit on a wall by using screws in the key holes on the
bottom side. The distance between the screws must be 90 mm. A
good place to mount the unit is just below the celing and letting the
cables go upwards to the ceiling.
The screws must be at least 3.5 mm wide and 30 mm long.
5
Configuration
Normally no configuration is needed when REPO+ II is used to repeat
all radio alarms unchanged.
If a custom configuration of REPO+ II is needed, this can be achieved
with a computer and the software IOR Family Programmer. This is
described in the Technical Handbook for the IOR Family, document
number NE41 06007-02.
5.1
Radio modes
By defult the REPO+ II is in Transparent Mode, i.e. an incoming radio
and alarm code is simply forwarded.
5.1.1
Transparent mode
This is the default mode. No changes are made to incoming radio
and alarm codes and these are forwarded un-altered.
6
REPO+ II - NE41 18002-00 v1.0
Werbung
Inhaltsverzeichnis
