Reimo Carbest 83179 Bedienungsanleitung Seite 9

UK
V. PROGRAMMING (CODE CLEARING AND CODE MATCHING )
Code matching:
For a new kit (remote& controller), the remote can work only when it is programmed to
the controller.
Please follow the below instructions:
Correctly connect the power supply, LED controller and LED load.
Switch off the main power, then switch on again (not via remote control), and press key
5 once (within 3 seconds). The LED strip blinks twice slowly when it is done.
Code clearing:
The code can be cleared as needed.
The kit (remote and controller) will stay in the original state after code clearing. lt can
work when code rematching is done.
Please follow the below instructions:
Correctly connect the power supply, LED controller and LED load. Switch off the main
power, then switch on again (not via remote control), and long press key 5 (within 3
seconds). The LED strip blinks nine times swiftly when it is done.
Attention:
The regular product is a kit (remote and controller).
The user can re-programme freely as needed. One remote can control countless control-
lers, but one controller can only be controlled by four remotes (max).