(Up To 199 Minutes) - JOBO ProTime100 Bedienungsanleitung

At the end of the selected program, the display
will show the program number and the word
'End' will flash on the display. In addition, the
unit will give audio signals as follows:
Press START to return to the first process step.
How to skip process steps:
To skip process steps keep START pressed
continously.
Reset
To reset the program whilst it is running, switch
the unit off, then on again.
5. Programming of individual processes

(up to 199 minutes)

Nine programs are available with the Jobo Pro-
Time 100, and each program allows up to 13
steps to be edited with the desired time in minu-
tes and seconds up to a maximum of 199 minu-
tes. This data is stored even if the battery needs
to be replaced.
Selection of the appropriate program
• Switch the unit on. The current program
No. is displayed for two seconds.
• Press START and UP, and scroll programs
upwards using UP button
14
Every ten seconds after program end:
3 beeps for 5 mins
Every minute after program end:
1 beep