How To Use - Airthereal PA50-GO Handbuch

HOW TO USE

1. Press and hold the power button for 3 seconds to turn on the power. The power indicator
light will be illuminated in red while the power is turned on.
2. According to your needs, select the corresponding ozone function mode.
• HOLD: Runs continuously up to 4 hours.
• 15/45: Runs for 15 minutes, standby for 45 minutes, repeat. Lasts up to 4 hours, or up to
4 complete cycles.
• 1h: Runs for 1 hour then powers off.
• 2h: Runs for 2 hours then powers off.
3. When the product is fully charged it can run for 4 hours. When the power indicator is flashing
red, it means that the battery is low and needs to be charged.
4. This product is pre-charged with 70% -80% battery when it leaves the factory. If it cannot be
turned on normally, please contact support@airthereal.com.
5. Use the original Micro-USB cable to charge the product. When the input current is 2.1A,
charging can be completed in approx. 4hours. If the input current is lower than 2.1A or using
other Micro-USB cables may extend the charging time.
6. While charging, the power indicator light will continuously flash white. Charging is complete
when the power indicator stops blinking and displays a continuous white light.
7. To protect the battery and extend the service life of the ozone machine do not use the ozone
machine during charging.