nordholm Stick Gebrauchsanweisung Seite 9

The towel warmer must be positioned horizontally in order for it to function correctly. The towel warmer
must be positioned according to the applicable standards. The minimum distances as specified in picture
1 should be carefully observed (the recommended distance from the floor is 600 mm).
The towel warmer may be positioned "outside" zone 2 with the standard connection box and inside zone
2 if the connection box is equipped with a splash proof cover (picture 2), insofar as no operating controls
(button, switches, etc ...) are in reach of persons in the bath or under the shower. The towel warmer must
be fixed to the wall using the wall brackets supplied. The towel warmer must not be located underneath
an electrical socket.
min. 600 mm
Figure 1
Figure 2
5. Warranty, maintenance and care
WARNING: Disconnect electrical supply before carrying out any maintenance activity. The product should
be cleaned using a soft damp cloth. Do NOT use chemical or abrasive cleaners as they will damage the
surface finish. If the supply cord is damaged, it must be replaced by the manufacturer, a service agent or
similar qualified persons in order to avoid a hazard.
The product is covered by a 5 years warranty except for the electrical and electronic components that
are covered by a 2 year warranty.
When the towel warmer reaches the end of its service life follow the regulations concerning
the disposal of electrical waste.
Zone 1
Zone 0
Zone 0
Zone 3
Zone 1
Zone 2
Zone 0
9
Zone 2