Using The Total Crushing Jug - Ninja BN750EU Bedienungsanleitung

USING THE TOTAL CRUSHING® JUG
IMPORTANT: Review all warnings
on pages 36-38 before proceeding.
IMPORTANT: As a safety feature, if the
Jug and lid are not properly installed, the
timer will display "... ..." and the motor
will be disabled. If this happens, repeat
step 5 on the following page. When the
Jug and lid are properly installed, the
program button LEDs will illuminate,
indicating the appliance is ready to use.
NOTE: Auto-iQ® programs have pauses
and changes in speed throughout
the cycle�
NOTE: DO NOT add ingredients before
installing the Stacked Blade Assembly�
NOTE: If the Stacked Blade Assembly is
not fully seated, you will not be able to
install and lock the lid�
NOTE: The handle on the jug lid will not
fold down unless it is attached to the
jug�
42 ninjakitchen.eu
1 Plug in motor base and place on a clean,
dry, level surface such as a worktop or
table�
2 Lower the Total Crushing Jug onto
the motor base� The handle should be
aligned slightly to the right and the Jug
should be oriented so the LOCK symbols
are visible on the motor base� Rotate the
Jug clockwise until it clicks into place�
3 Exercising care, grasp the Stacked
Blade Assembly by the top of the shaft
and place it onto the drive gear inside
the Jug� Note that the blade assembly
will fi t loosely onto the drive gear�
4 Add ingredients to the Jug� DO NOT
add ingredients past the MAX LIQUID
line on the Jug�
5 Place the lid on the Jug, aligning the
triangle symbol on the lid with the
triangle symbol on the handle� Press
down on the handle until it clicks into
place� The triangle symbols MUST be
aligned for the lid to lock and the unit to
operate� Once the lid is locked in place,
press the Power button to turn unit
on� The available program buttons will
illuminate and the unit will be ready
for use�
6a If using an Auto-iQ® program, fi rst select
the program that best suits your recipe�
The preset feature will automatically stop
at the end of the program� To stop the
unit at any time, press the currently active
button again�
6b If using a manual program, select your
desired speed� Once the ingredients
have reached your desired consistency,
press the active button again, and wait
for the unit to come to a complete stop�
7 To remove the Jug from the motor
base, turn the Jug anti-clockwise
and then lift up�
8a To pour out thinner mixtures, ensure
the lid is locked in place, then open the
pour spout cap�
8b For thicker mixtures that cannot be
emptied through the pour spout,
remove the lid and Stacked Blade
Assembly before pouring� To remove
the lid, press the RELEASE button and
lift the handle� To remove the blade
assembly, carefully grasp it by the
top of the shaft and pull straight up�
The Jug can then be emptied�
9 Turn the unit off by pressing the Power
button� Unplug the unit when fi nished�
Refer to the Care & Maintenance section
for cleaning and storage instructions�
43
ninjakitchen.eu