Functional Instructions; Features And Operational Controls - Hifionics Medusa Serie Benutzerhandbuch

PROCESSOR FEATURES AND OPERATIONAL CONTROLS
4
If the POWER LED lights up, the amplifier is ready for operation.
1
The eight LINE OUT RCA jacks provide audio signals for amplifiers, which can be modified and configurated with the DSP soft-
2
ware.
If necessary, connect the mini-USB port by using the enclosed USB cable to the computer on which the M-CONTROL soft-
3
ware is installed. The connection can be released after using the DSP software.
Do not extend the cable in any way with a passive USB extension because otherwise a flawless communication between the
DSP processor and the PC can not be ensured. If you have to bridge longer distances, use an active USB extension with
integrated repeater. The LED next to the USB port lights up blue when a connection between DSP device and computer is
made via the USB cable.
The OPTICAL input is suited for a Toslink cable connection with an external audio source that provides a SPDIF signal (stereo
4
PCM).
The REMOTE port is for the enclosed remote controller. Please refer to the information on the next page.
5
The SUB IN RCA jacks must be connected with the RCA output jacks of the head unit (Subwoofer Output).
6
The HIGH LEVEL INPUT (enclosed cable set with plug) can be used, if your head unit is not equipped with RCA pre-amplifier
7
outputs. You can connect then instead the loudspeaker outputs of your head unit with the highlevel input cable set accordingly
(refer to the assignment on the next page right above.
Note: Please also refer to the information AUTO TURN ON function on page 19, section #2.
Note: Never use the HIGH LEVEL INPUT function and the RCA inputs (#6 and #8) at the same time together. This may
damage the electronics of the processor.
The LINE IN RCA jacks must be connected with the RCA output jacks of the head unit (2 x Stereo Output Front/Rear).
8
The AUX IN 3,5 mm jack can be connected with with external audio sources like MP3 player, smartphones, navigation systems.
9
20

FUNCTIONAL INSTRUCTIONS

OPTICAL
INPUT SUB R
REMOTE
1
POWER
A B
OPTICAL
INPUT SUB R
REMOTE
5 6
–
POWER
A B
–
M8-DSP DIGITAL SOUND PROCESSOR
SUB L RR RL FR
HIGH LEVEL INPUT
2
OUTPUT
C D E
M8-DSP DIGITAL SOUND PROCESSOR
SUB L RR RL FR
HIGH LEVEL INPUT
7
+
OUTPUT
MODE OK INPUT SEL.
C D E
+
MODE OK INPUT SEL.
POWER INPUT
MAIN
FL
INPUT
AUX
INPUT
PC LINK
F G H
POWER INPUT
MAIN
FL
INPUT
AUX
INPUT
MAIN
8 9
AUX
OPTICAL
PC LINK
F G H
MAIN
AUX
OPTICAL
GND
+12V
REM IN
REM OUT
3
USB
GND
+12V
REM IN
REM OUT
USB