Hifonics HFC1000 Bedienungsanleitung Seite 15

DISCHARGING PROCESS
If the capacior will be de-installated you need to discharge it completely. To
discharge the capacitor, remove the wire at the "+" terminal of the capacitor.
Keep the ground terminal "-" connected. Then bridgeover the "-"pole and "+"pole
of the capacitor with the supplied light bulb.
The discharging process could last some minutes.
To checkup the status, the remote signal (head unit ON) has to be turned on.
It is recommended to use a gripper during this procedure, because the light
bulb may get very hot.
A sound blip is hearable during the discharging a (below 10 Volts) and the
Control-LED is flashing. If the light bulb stops flashing, the discharging process
is accomplished.
Never discharge the capacitor without the supplied light bulb.
Never discharge the capacitor with bypassing the terminals (short circuit).
The capacitor may get damaged or explode.
Light bulb
Remote
"+" Battery
"–" Ground
Terminal
Terminal
VOLTMETER ADJUSTMENT
The adjustment is already done by the factory, but can be redone if necessary.
By using additional capacitors, various indicated values could be occured. This
can be adjusted by the potentiometer.
Follow these instructions:
1.) Measure the actual operating voltage on the "+" und "–"pole of the capacitor
by using an appropriate multimeter.
2.) Remove the plexi-cover of the capacitor and adjust the value with the
potetiometer by using a appropriate screwdriver to the same value, you have
measured before.
3.) Ensure while removing the cover, not to short the terminals.
4.) Or assign your car audio retailer.
15