Inhaltsverzeichnis
Werbung
EN
ASSEMBLY
1. Place the structure of the marquee upright in the centre of the place where it will be built. Do
not attempt to move the marquee when it is installed.
2. Carefully place the tarpaulin over the structure so that the centre and the corners align with
the frame (A). For larger models, expand the frame of the marquee almost completely before
placing the tarpaulin on the structure. Never use excessive force when placing the tarpaulin
as it might break. Make sure the tarpaulin is not snagged anywhere the frame and is properly
oriented (the long side of the canvas in the long side of the marquee frame, and corners of
the tarpaulin in the corners of the frame).
3. Carefully slide the tarpaulin over the legs of corners and make sure to hold firmly with the
Velcro straps.
4. From opposite sides of the structure, grab the middle section of the frame with both hands
(B). Simultaneously lifting the frame sections and move slowly backwards, allowing the frame
to expand to its full size (C). To collapse the frame of the marquee requires a minimum of 2
people for smaller models, and 4 people for larger models.
5. Assemble the top frame in the leg tube - hold the top section of the leg firmly and slide roof
frame through it until the safety pin of the tube gets into the hole and locks itself (D).
6. Secure the sides of the tarpaulin to the structure using the elastic, clips, and/or Velcro straps.
7. Lift the roof of the marquee at the required height, holding the bottom part of the leg to the
ground and raising the telescoping section until the safety pin is inside the hole. To lift it even
higher, push the pin with the thumb gently pressing the telescopic section until it goes into
the next available hole.
8. Included accessories:
A
B
CARPLE 3X6
6
12
Werbung
Inhaltsverzeichnis
