Changing The Ring Tone For The Call Button; Replacing Batteries; Resetting The Pager To Factory Settings - Tiiwee Pager Handbuch

Changing the ring tone for the call button

Note: The factory setting for the ring tone is "Ding Dong". However, you can
choose from 58 melodies.
IMPORTANT: In step 2, the call button is eliminated from the receiver and then
reconnected in step 3. If no call button is pressed within the 5 seconds as
described in step 2, the connection between the call button and the receiver is
lost, and you will need to go through the steps 1 to 3 again.
Choose your favourite ring tone by pressing the Sound button with the tip of a pen.
1.
Press the Volume button for 5 seconds until you hear a low buzzing sound and the
2.
LED indicator flashes continuously - you are now in pairing mode.
Now, press the call button within 5 seconds. You will hear the selected sound on
3.
the receiver. The receiver will vibrate, and the LED indicator light will flash.
Your new settings now have been stored.
4.

Replacing Batteries

The average battery life of the vibration receiver is about three months. The
average battery life of the call button is approximately 10-12 months.
Battery type call button: CR2032
Battery type receiver: 2 x 1.5 V AAA
Note: Please always use high-quality batteries for the receiver and the call button.
Note: The receiver will not lose its setting after battery replacement.
Note: The system does not feature a low battery warning. Therefore, we
recommend checking the functionality of the pager each time or each day before
use. A good practice is to make this part of your standard routine.

Resetting the Pager to Factory Settings

(deleting call button from the receiver)
· With the tip of a pen press the Sound button for 5 seconds.
· You will hear a low buzzing sound.
· The call button his now disconnected from the receiver.
· The ring tone sound has been reset to the factory setting ("Ding Dong").
· You can now connect the call button again by following the steps outlined in the
section "Changing the ring tone for the call button".
5