Audiotec Fischer MATCH UP C42MB-FRT Bedienungsanleitung Seite 13

Installation of the UP X4MB-FRT
The UP X4MB-FRT is a 2-way coaxial system,
which will be installed in the original midrange
speaker position. After you have dismantled the
cover, you can remove the original midrange speak-
er. Then connect the UP X4MB-FRT to the original
speaker cable harness and insert it into the original
mounting position (see figure page 12, refer to item
"Installation of the UP C42MB-FRT").
Installation of the UP S4MB-CTR / UP S4MB-SUR
The center speaker UP S4MB-CTR and the sur-
round speakers are fullrange speakers, which will
be mounted in the original speaker locations. After
you have dismantled the cover, you can remove
the original fullrange sepaker. Then connect the
MATCH UP S4MB-CTR / UP S4MB-SUR to the
original speaker cable and insert it into the original
mounting position.
Important: The center speaker is equipped with
two equal connection terminals. For audio transmis-
sion only one terminal is required. If there is no mu-
sic-playing center speaker or if there is an additional
amplifier as recommended, use the enclosed cable
to connect the signal source. The other terminal
must only be connected if the car is equipped with
a SOS emergency call function ex works. Please
refer to the user manual of the vehicle.
Installation of the UP S4MB-SUR / UP S4MB-CTR:
Important: Make sure that all anchoring supports of
the speaker are correctly engaged.
Installation of the UP W8MB-S4
For the installation of the front subwoofers you have
to remove the splashback cover in the front footwell.
Then connect the MATCH UP W8MB-S4 subwoofer
to the original speaker cable harness, insert it into
the original mounting position and fix it with the
screw nuts.
Installation of the UP W8MB-S4:
The enclosed universal connection cables with
50 cm / 1.64´ and 1.5 m / 4.92´ length can be used
e.g. for connecting an optional amplifier.
13