Rear Panel Controls; Protection - DIGAM Powersoft Q5001 Bedienungsanleitung

Rear panel controls

1)
Female Neutrik Speakon connectors for audio output for each channel (2+ / 2- for Bridge Mode)
2)
Female Cannon XLR connectors or Jack stereo (COMBO) for input signal for each channel
3)
AC main cord
4)
Cooling fan outlet
5)
Parallel signal switch
3

Protection

Turn-On/Turn-Off Muting
For about four seconds after turn-on, and immediately at turn-off, the amplifier outputs are muted.
Short circuit protection
A short circuit protection system safeguards the amplifier's output transistors under short circuits and
other stressful loads. It is completely inaudible when inactive. In case of short circuit, the
PROTECTION LED will be lightened. Turn OFF/ON the amplifier to reset protection mode status.
Thermal protection
A DIGAM amplifier uses a continuously variable speed fan to assist cooling (the fan speed
changes in response to the amplifier's cooling needs). If the heat sink temperature reaches
approximately 60°C, the TEMP LED starts to flashing. If the temperature is more then 70°C the
thermal sensing circuitry will mute each power section channels, the TEMP LED will be light
permanently and the power supply will be inhibited. Once the heatsink has cooled down, the
amplifier will automatically unmute and the TEMP LED will be unlighted. It will be possible to
reduce the temperature reducing the output power.
POWERSOFT
4
2
Fig. 2: Rear panel
ENGLISH - 7
1 2 2
1
5
1
1
2
5
E