Herunterladen Diese Seite drucken

OSRAM OPTOTRONIC OT FIT 15/220-240/350 NFC Installations- Und Betriebshinweise Seite 2

Werbung

OT FIT 15/220-240/350 NFC | OT FIT 25/220-240/700 NFC | OT FIT 40/220-240/1A0 NFC
 Installing and operating information:
Connect only LED load type. LED module will be switched
off when output voltage drops below 18V or rises above
40V.
Wiring information (see fig. A):
Do not connect the outputs of two or more units. Output
current adjustment via NFC (Near Field Communication)
in mains off mode only. Unit is permanently damaged if
mains is applied to the terminals 21/22. Lines 21/22 max.
2 m whole length excl. modules. Hot plug-in or secondary
switching of LEDs is not permitted.
Hereby OSRAM GmbH declares that the radio equipment
types OT FIT 15 NFC, OT FIT 25 NFC and OT FIT 40 NFC
are in compliance with Directive 2014/ 53/ EU. The full text
of the EU declaration of conformity is available at the fol-
lowing internet address: www. osram. com/ot-indoor-ce.
Frequency range: 13 553 – 13 567 kHz
Technical support:
www.osram.com, +49 (0)89-6213-6000
1) Constant current LED Power Supply; 2) t c point; 3) Made
in China; 4) picture only for reference, valid print on prod-
uct; 5) Mains; 6) Input; 7) Output; 8) Year; 9) Week
 Installations- und Betriebshinweise:
Schließen Sie nur LED-Lasttypen an. Das LED-Modul wird
abgeschaltet, wenn die Ausgangsspannung unter 18V sinkt
oder über 40V steigt.
Verdrahtungshinweise (siehe Abb. A):
Die Ausgänge von zwei oder mehreren Geräten dürfen
nicht verbunden werden. Die Ausgangsstromeinstellung
erfolgt nur im netzspannungsfreien Zustand über NFC
(Nahfeldkommunikation). Das Gerät wird dauerhaft be-
schädigt, wenn an die Klemmen 21/22 Netzversorgung
angelegt wird. Max. Gesamtlänge der Leitungen 21/22
ohne Module 2m. Der Anschluss von LEDs im laufenden
Betrieb oder sekundäres Schalten ist nicht zulässig.
Hiermit erklärt die OSRAM GmbH, dass die Funkanlagen-
typen OT FIT 15 NFC, OT FIT 25 NFC und OT FIT 40 NFC
der Richtlinie 2014/53/EU entsprechen. Der vollständige
Text der EU-Konformitätserklärung ist unter der folgenden
Internetadresse verfügbar: www.osram.com/ot-indoor-ce.
Frequenzbereich: 13 553 – 13 567 kHz
Technische Unterstützung:
www.osram.com, +49 (0)89-6213-6000
1) Konstantstrom-LED-Betriebsgerät; 2) t c -Punkt; 3) Her-
gestellt in China; 4) Foto dient nur als Referenz, gültiger
Aufdruck auf dem Produkt; 5) Netzversorgung; 6) Eingang;
7) Ausgang; 8) Jahr; 9) Woche
2
 Informations pour l'installation et le fonctionnement :
Branchement avec type de charge LED uniquement. La
coupure de charge survient si la tension de sortie US est
inférieure à 18V / supérieure à 40V.
Informations de câblage (voir fig. A) :
Ne pas brancher les sorties de deux unités ou plus. Confi-
guration du courant de sortie via NFC (Near Field Com-
munication). Coupez impérativement l'alimentation secteur
au préalable. Le raccordement secteur aux terminaux 21/22
causera des dommages irréversibles à l'unité. Lignes 21/22
longueur totale max. 2 m hors modules. Le branchement
à chaud ou la commutation secondaire des LED ne sont
pas autorisés.
OSRAM GmbH atteste par la présente de la conformité
des équipements radio OT FIT 15 NFC, OT FIT 25 NFC ou
OT FIT 40 NFC avec la directive 2014/53/UE. Le texte de
cette déclaration UE de conformité peut être consulté dans
son intégralité à l'adresse suivante : www. osram. com/
ot-indoor-ce.
Bande de fréquences : 13 553 – 13 567 kHz
Support technique :
www.osram.com, +49 (0)89-6213-6000
1) Alimentation LED courant constant; 2) Point T c ; 3) Fa-
brique en Chine; 4) image non contractuelle, se référer aux
inscriptions sur le produit; 5)  Alimentation électrique;
6) Entrée; 7) Sortie; 8) Année; 9) Semaine
 Informazioni su installazione e funzionamento:
Collegare soltanto tipi di carico LED. Lo spegnimento del
modulo LED avviene se la tensione di uscita è inferiore a
18V/superiore a 40V.
Informazioni sul cablaggio (vedi figg. A):
Non connettere le uscite di due o più unità. Regolazione
corrente in uscita via NFC (Near Field Communication)
solamente con rete in modalità spento. L'unità è danneg-
giata permanentemente se la tensione di rete viene appli-
cata ai terminali 21/22. Linee 21/22 max. 2 m di lunghez-
za totale, moduli esclusi. Non sono permessi l'hot swap o
lo switching secondario dei LED.
Con la presente, OSRAM GmbH dichiara che gli equipag-
giamenti radio di tipo OT FIT 15 NFC, OT FIT 25 NFC e OT
FIT 40 NFC sono conformi alla direttiva 2014/53/EU. Il
testo completo della dichiarazione di conformità europea
è disponibile sul seguente indirizzo: www.osram.com/ot-
indoor-ce.
Intervallo di frequenza: 13 553 – 13 567 kHz
Supporto tecnico:
www.osram.com, +49 (0)89-6213-6000
1) Alimentazione LED a corrente costante; 2) Punto t c ;
3) Prodotto in Cina; 4) immagine solo come riferimento,
stampa valida sul prodotto; 5) Rete; 6) Ingresso; 7) Uscita;
8) Anno; 9) Settimana

Werbung

loading

Diese Anleitung auch für:

Optotronic ot fit 25/220-240/700 nfcOptotronic ot fit 40/220-240/1a0 nfc