User Guide; Daily Use - Leander LUNA Bedienungsanleitung

USER GUIDE - IMPORTANT!
SAVE FOR FUTURE USE.
READ CAREFULLY.
EN Baby cot/bed
The baby bed base can be set at two different
heights. Upper position and lower position.
Make sure that the distance from the mattress
to the top of the bed frame is never less than
300 mm in the top position or 500 mm in the
bottom position. This is marked one the inside
of two of the bedframe corners.
By using an original Leander® mattress, you
are assured of the correct distance to top of the
bed. It is always safest to place the bed base in
the lower position.
As soon as your baby can sit up or stand up on
his/her own, the cot/bed base must be placed
in the lower position. See assembly for further
instructions. (Position 2)
To prevent injuries from falls, when the baby
can crawl out of the cot/bed by himself/herself,
this bed shall no longer be used for that child.
Make sure that medicines, strings, small toys,
small objects such as coins, etc. are out of the
baby's reach from any position in the cot/bed.
Always follow the assembly instructions in
detail to ensure the safety features of the cot/
bed are not compromised!
WARNING
• Never place the child's bed by an open fire or source of
strong heat such as electric heaters, gas heaters, power
points etc. due to the risk of fire.
• Do not use the child's bed if any parts are damaged
or missing and only use replacement parts that are ap-
proved by Leander.
• Never leave anything in the child's bed and never place
the child's bed close to something the child can stand on,
or which may pose a risk of suffocation or strangulation,
such as ribbons, strings on blinds/curtains, etc.
• Never place more than one mattress in the child's bed.
• Always use the original Leander mattress, as it is de-
signed to fit the bed's shape. The use of other mattresses
4
Recommended mattress size
This cot/bed has been manufactured for use
with a mattress which measures 700 mm wide
by 1400 mm long and maximum 105 mm in
thickness. The width and length are specified
because it is important that the gaps between
the mattress and the sides and ends of the cot
will not exceed 30 mm.
This is to minimize the risk of a child's limb be-
coming caught in the gap. The thickness of the
mattress has been specified to ensure that the
depth of the cot is greater than 500 mm with
the mattress base in the lower position and at
least 300mm in the highest position to minimize
the risk of a child climbing or falling out of the
cot/bed.
Cleaning and maintenance
WOODWORK: Can be wiped off with a damp
cloth. Surplus water must be wiped off. The
color may change when exposed to sunlight.
DAILY USE: Remove the quilt every morning
allowing both bed and quilt to be aerated, cool
off and dry.
Product information
Lacquer complies with the European standard
EN71-3. DIN EN 716-1:2008 +1A: 2013
Designprotected
can cause gaps between the mattress and bed in which
the child can become trapped.
• To prevent falls, mattress base of this cot should be
adjusted to the lowest position before the child can sit up.
• After assembly, all fittings and screws must be checked
and tightened. A poorly assembled bed and loose parts
may lead to the child trapping a body part or to clothes
(e.g. strings, necklaces, strings on dummies, etc.) becom-
ing stuck and posing a risk of strangulation.
• Make sure the cot is placed on a level and stable
surface.
• Remember to keep the Allen key after assembly. After 2
to 3 weeks of use, all screws should be tightened.