Copy An Original Infrared Command To A Device Key - VINCENT RC-572 Bedienungsanleitung

Copy an original infrared command to a device key

Even the device keys on the HOME page have the ability to learn an
infrared command that is sent every time the key is pressed. It is not pos-
sible to delete this command later without deleting the key; you can only
overwrite the old command in a new learning process.
Downloaded from www.Manualslib.com
3. After a learning
trial other devi-
ce keys can be
programmed in
the same way,
just touch the
desired key.
manuals search engine
1. On the HOME page select
MENU, then LEARN, followed by
LEARN DEVICE. Choose the devi-
ce key that is supposed to receive
the new function, if necessary use
the page selection keys (6)(7).
2. The display reads "Learning..."
and both remote controls should
oppose each other. Hold down
the original remote control key
until the display reads "Learn
OK!". If the signal is received
erroneous, the display shows the
text "LEARN ERROR" and the old
infrared function (if any) of the
device key will be kept. If no sig-
nal is received, the display reads
"NO DATA" and the old infrared
function (if any) of the device key
will be kept. Check in both cases
if the batteries of the original
remote control are used up and if
both controls are positioned face-
to-face while learning.
Vincent
71