Using The Machine - Clatronic DBS 2580 Bedienungsanleitung, Garantie

38417-05-DBS 2580
Numbering of the Controls
1. Steam regulator
with self-clean function
2. Filler aperture of the water tank
3. Temperature control
4. Water tank
5. Base
• Clean the ironing base with a slightly damp cloth.
• Fill the water tank through the filler aperture (2) with pure water (up to degree of
hardness 2). If the tap water is harder please use distilled water. Use the filling
vessel.
NOTE: Only clothes should to be ironed with this machine.
Ironing without steam (steam regulator turned to position "0")
1. Place the iron on its stand
2. Sort out the garments according to their ironing temperatures. Start with the
lower temperatures. It is set with the thermostat (3):
Synthetics, silk
Wool
Cotton, linen
3. Insert the plug into a correctly installed safety power socket, 230 V, 50 Hz.
4. The control lamps light up. As soon as the blue control lamp goes off the opera-
ting temperature has been reached (approximately 3 minutes). Now you can
start ironing.
5. Always pull the plug out of the socket after using the iron.
Steam Ironing
For this a high temperature is needed (cotton, linen). The quantity of steam can be
regulated using the steam quantity regulator (1).
Vertical Steam
This can be used to produce a jet of steam in a vertical direction.
Self-Cleaning
1. Half fill the water tank with water.
2. Heat the machine up to its maximum temperature. After the blue control lamp
has gone off, disconnect the machine from the mains.
08.09.2004 16:48 Uhr
First Use of the Machine
6. Spray button
7. Steam-jet button
8. Control lamps
9. Contact plate
10. 3-position function switch

Using the Machine

(low temperature)
(medium temperature)
(high temperature)
Seite 31
31
GB