Safety Precautions; Troubleshooting - PALSON Perfect Gebrauchsanleitung

GB
Our products are developed to meet the highest quality, performance and design standards. We hope you enjoy your new
PALSON Perfect nose and beard trimmer.

saFety PreCautions

When using electrical appliances, certain basic safety precautions must be followed, including the following:
- Read all of the instructions before using the appliance.
- This product is equipped with safety features.
- Read the safety precautions carefully and only use this product as indicated in these instructions in order to avoid
injury or damage.
- Keep these instructions for future use.
- If you give this appliance to someone else, do not forget to include these instructions.
- The trimmer has been designed to trim hair in the nose and ears, sideburns and on the neck. It is intended for
domestic use only and is not suitable for professional use.
- Do not use the trimmer on children. Keep the appliance out of children's reach.
- Non-reusable and rechargeable batteries may cause death if swallowed. Therefore, keep the battery and trimmer out
of children's reach. If a battery has been swallowed, see a doctor immediately.
- Do not insert the trimmer more than 0.5 cm into the ear or nostril as this may cause injury to the eardrum or nasal
mucous membrane.
- When using the trimmer, make sure that the clipping head or trimming attachment are firmly attached.
- Non-rechargeable batteries must not be recharged or reactivated, taken apart or thrown in the rubbish. When
depleted, take to the appropriate recycling container.
- When cleaning the appliance, make sure that the battery lid is tightly closed.
- Never immerse the appliance in water.
- Stop the appliance after use, replace the clipping head (if it has been taken off), and put on the protective cap.
- Immediately remove a depleted battery from the appliance as it may leak and cause damage.
- This product must not be used by children or by other people without assistance or supervision if their physical,
sensory or mental condition limits safe use of the appliance. Children must be watched to make sure that they do not
play with the appliance.
inserting the battery
The appliance operates with a 1.5V AA LR6 battery. It is best to use an alkaline battery. However, the appliance can also
operate with an AA rechargeable battery.
- Turn the battery lid anticlockwise and remove. The battery lid has a bayonet type latch.
- Insert the battery with the positive terminal (+) facing the clipping head.
- Replace the battery lid and turn clockwise until it fits into place.
use
Warning: Do not insert the trimmer more than 0.5 cm into the ear or nostril as this may cause injury to the eardrum or
nasal mucous membrane.
attention: always use a mirror
1. turning on the trimmer
- Remove the protective cap.
- Move the ON/OFF switch towards the clipping head.
2. turning off the trimmer
- Move the ON/OFF switch towards the battery lid.
- Clean the trimmer (see "Cleaning").
- Fit the clipping head and then place the protective cap on the clipping head.
3. trimming ear hair
- Turn on the trimmer and insert carefully in the outer ear.
- Carefully move the trimmer along the areas with ear hairs.
4. trimming nostril hair
- Turn on the trimmer and insert carefully in the nostrils.
- Remove nose hairs by carefully moving the trimmer in a circular motion.
5. Defining trim lines
- Turn off the trimmer.
6
Downloaded from www.Manualslib.com manuals search engine
- Turn the clipping head clockwise and replace with the trimming attachment.
- Apply the trimmer to the skin without pressing. Do not push the trimmer forwards or sidewise as this may cause
cuts.
Cleaning
Caution: Never immerse the appliance in water.
Always clean the trimmer after use.
after each use
- Turn off the trimmer before cleaning.
- Rinse the clipping head and trimming attachment in hot water.
- Wipe the outside of the trimmer with a dry cloth.
- Replace the protective cap on the trimmer.
Cleaning the stainless steel trimming system
- Turn off the trimmer.
- Turn the clipping head clockwise and lift off.
- Briefly rinse the drive shaft.
- Rinse the clipping head with the stainless steel trimming system under running water and leave to dry.
- Position the clipping head and turn anticlockwise until it fits into place.
- Wipe the outside of the trimmer with a dry cloth.
- Replace the protective cap on the trimmer.
- Clean the stainless steel trimming system after every three uses of the nose and ear trimmer.

troubleshooting

- The trimmer does not work
- The motor operates irregularly
- The motor stops
Thank you for choosing one of our products.
- Low battery?
- Clipping head dirty?
- Is the battery compartment lid fitted properly?
7