Herunterladen Inhalt Inhalt Diese Seite drucken

Changes To The Controller; Getting In And Out - B+B Centuro S7 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Centuro S7:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Centuro S7
| Scooter
Horn
The horn (Fig. 19) enables you to draw attention to yourself in difficult
situations.
Ignition key
Switch the scooter off and on using the ignition key.
19
(Fig. 20).
USB Port
There is a USB port on the inside of the steering column, below the
handlebar (Fig. 21). You can use this to conveniently charge your
smartphone or other mobile terminals when your scooter is switched
on. The max. current supply is 1 A/5 V.
20
Mileage
You can display your mileage in kilometers (km) or in miles (mi). Press
the MODE button twice until the mileage indicator flashes. Use the
H/L key to switch between units. To confirm your selection, hold down
the SET button for at least 3 seconds.
Time
To set the time, press the MODE button three times until the time
21
flashes. You can switch between „AM/PM" and a 24-hour display by
pressing the H/L key.
Set the hours by pressing the left arrow key (blinker). Set the minutes
using the right arrow key (blinker).
To confirm your selection, hold down the SET button for at least 3
seconds.
Temperature
You can choose to display the ambient temperature in degrees Celsius
(°C) or Fahrenheit (F). Press the MODE button four times until the
temperature indicator flashes. Use the H/L key to switch between °C
and F. To confirm your selection, hold down the SET button for at least
3 seconds.
52
After pressing the MODE button, the selected dis-
play flashes three times. If you do not make any
changes during this time, you will leave the menu
automatically.

4.1.1. Changes to the controller

Changes to the programming of the controller may only be made by an
authorized supplier. Changes to the programming have an effect on the
speed, acceleration and deceleration. This can lead to life-threatening
injuries of the user and / or third persons if improperly carried out

4.2. Getting in and out

Ensure that the scooter is switched off before sitting on it.
Move the steering column, as described previously, into the upright
position and swivel back the arm rest on the side from which you
intend to sit down so that the arm rest is out of the way.
It is easier for you to sit down if you rotate the seat 90° to the side
from which you intend to sit down (see the section entitled Basic
adjustments).
Now sit down.
Rotate the seat in the driving direction or swivel the arm rest
forwards again.
Adjust the steering column so that you can comfortably reach all
the controls.
To get out, follow the instructions accordingly in reverse order.
However, take out the key beforehand so that you can ensure that
no unintended actions or movements occur.
Ensure that the seat firmly locks in position
again
Bischoff & Bischoff GmbH |21.07.2020 - revision 3
Centuro S7
Scooter |
53

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis