Hellberg Xstream Kurzanleitung Seite 5

A13: Volume UP an next track
A14: On/Off button
A15: Level dependent button (only on Xstream LD)
Accessories and spare parts (pic. B)
B:1. Hygiene kit: 99403-001
B:2. Sweat absorbers: 99900-001
B:3. Windshield boom microphone: 16999-001
B:4. USB charging cable: 39926-001
B:7. Boom microphone: 16982-001
B:8. Windshield level dependent microphones: 1059-001
Changing the hygiene kit (pic. D)
1. Remove the old sound absorber foam and insert the new.
2. Pull off the old ear cushion.
3. Centre the new ear cushion over the hole.
4. Press with a finger along the outside of the ear cushion until it attaches all around the edges.
5. Pull off the old head cushion and insert the new.
Approval and technical data (E)
E:1) Headband
E:2) Helmet/Cap mounted
E:3) Tested and certified to (standards)
E:4) Weight
E:5) Mean attenuation
E:6) Standard deviation
E:7) Assumed Protection Value
E:8) Tested by (notified body)
E:9) Headband force
E:10) Size: S, M & L
Approved helmet combinations
These earmuffs should be fitted to, and used only with the industrial safety helmets listed in table G.
G:1) Manufacturer
G:2) Model
G:3) Adapter
G:4) Warning! These helmet mounted hearing protectors are suitable for persons with medium to large head size circumference
(56-64 cm) and with medium to large height from the top of the head to the centre of the ear canal. A smaller height may lead to
improper fit and reduce the hearing protector´s noise attenuation properties.
Earmuffs complying with EN 352-3 are of medium size range or small size range or large size range. Medium size range
earmuffs will fit the majority of wearers. Small size range or large size range earmuffs are designed to fit wearers for whom
medium size range earmuffs are not suitable.
Hereby, Hellberg Safety AB declares that the hearing protector "Xstream" is in compliance with PPE regulation EU 2016/425
and the RED Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following Internet
address: www.hellbergsafety.com/doc
For traceability, refer to the serial number label placed on the bottom of the ear cup.
This product is covered by the Waste Electrical and Electronic Equipment Directive (WEEE) 2012/19/EU.
Do not dispose of your product as unsorted municipal waste. Batteries must be disposed of in accordance with national
regulations. Use local recycling system for electronic products.
Information required by E.P.A. (US)
The level of noise entering a person's ear, when hearing protector is worn as directed, is closely approximated by the difference
between the A weighted environmental noise level and the NRR.
Example:
1. The environmental noise level as measured at the ear is 92 dBA.
2. The NRR is 25 decibels (dB).
3. The level of noise entering the ear is approximately equal to 67 dB.
Caution. For noise environments dominated by frequencies below 500 Hz the C-weighted environmental noise level shall be
used. Warning. Improper fit of this device will reduce its effectiveness in attenuating noise. Although hearing protectors can be
recommended for protection against the harmful effects of impulsive noise, NRR is based on the attenuation of continuous noise
and may not be accurate indicator of the protection attainable against impulsive noise such as gunfire.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: 1) This device may not
cause harmful interference, and 2) this device must accept any interference received, including interference that may cause
undesired operation.
Canada Compliance Statement
WARNING This Class (B) digital apparatus complies with Canadian ICES-003. This device complies with Industry Canada's
licence-exempt RSS 247. Operation is subject to the following two conditions:
1) This device may not cause interference; and 2) This device must accept any interference, including interference that may
cause undesired operation of the device.