Jackson SAFETY Airmax Bedienungsanleitung Seite 52

LIGHT TRANSMISSION CURVE
100
T[%]
10
1
0,1
0,01
0,001
0,0001
300 400
DESCRIPTION OF JACKSON SAFETY
1. Solar cells
2. Photo-sensors (Photo diodes)
3. Filter housing
4. Liquid crystal shutter viewing area
5. Shade adjustment/Grinding selection
6. Sensitivity adjustment
7. Opening time delay adjustment
TROUBLESHOOTING
Breakdown or
poor performance
The filter does not
darken or opens
during welding.
Filter opens during
welding.
The filter triggers
spuriously.
Reaction time very
slow.
500 600 700
Wavelength
Possible
reasons
Sensors or solar
cell may be covered
with spatters or dirt.
Weak light source.
Strong sun, strong
lights, neighbouring
welder's arc light.
Ambient tempera-
ture is to low.
Ambient is to dark.
Shade 4
Shade 9
Shade 10
Shade 11
Shade 12
Shade 13
800 900 1000 1100
FILTER FEATURES
®
Recommended
solution
Clean the filter and protective screen with
soft cloth. If needed, replace the protec-
tive screen.
Increase the sensitivity, get closer to the
arc, do not cover the sensors and the
solar cell by hand, torch or other objects.
Increase the opening time delay.
Reduce the sensitivity, reduce the disturb-
ing ambient light sources.
Never use below -5°C.
The reaction time for the first arc only will
be 10 ms, then normally 0,4 ms.
LIGHT STATE
DARK STATE
1200 1300 1400
λ[nm]
G
Figure
7