Reimo Marina High Air 2.9 Aufbauanleitung Seite 13

REPLACING OR REPAIRING AN AIR TUBE
• Deflate the air tube fully. Never replace or repair a tube before deflating
it fully.
• Break the plastic ties on the sleeve of the air tube and unzip the sleeve.
Then remove the protective cover and air tube from inside the sleeve.
Break the plastic ties on the protective cover and unzip the protective
cover. Remove the PU bladder from inside the protective cover.
• If your are repairing a puncture always use a professional repair kit that is
meant to repair TPU material. It needs to be a flexible repair as the tube
is inflated and thus the tube flexes in use. Locate and repair the puncture
following the instructions in your repair kit.
• Once the puncture is repaired or your are simply replacing the tube, place
inside the protective cover being careful to ensure that it is not twisted as
a twist in the bladder could cause damage when it is inflated.
• Once the tube has been fitted zip the protective cover shut. You must
then relock the zips with a new plastic tie or simular solution. If you
do not re-lock the zips then you could well cause damage to your awning
when it is inflated. If the zips are allowed to come apart (even a small
amount) then when inflated the bladder will expand out of the gap caused
by the zips moving apart and will cause damage. Any damage caused by
failing to re-lock the zips is not covered by your warranty. Once the zips
are shut and locked on the protective cover place the cover back in the
sleeve.
• Then zip the sleeve shut and again you must then relock the zips with
a new plastic tie or simular solution. Failure to do so could cause dam-
age to your awning when inflated and is not covered by your warranty.
Marina HIGH Air 3.9
93705
13
UK