Olight R50 PRO SEEKER Handbuch

USER MANUAL
R50 PRO SEEKER / R50 PRO LE Kit
INSIDE THE BOX
R50 Pro Seeker: Flashlight (including battery), Holster, 5V 2.0A USB Adapter, Magnetic
Charging Cable, User manual
R50 Pro Le kit: Flashlight (including battery), Holster, Charging Dock, Installing accessories
(with magic patches) x 2, Double-sided Adhesive Tape with magic patch x 2, Wall plugs x
8, Screws TA3*15 x 8, DC 12V 1.5A Car Charger, DC 12V 1.5A AC Adapter, AC Adapter
Cable with plug, User manual
SPECIFICATIONS
Material: Aircraft-grade aluminum body with anti-scratch type-III hard anodizing
MAX
250 m 3200 lumens 15,600cd
1 m
Cree XHP70 CW 1 x 26650 (customized)
10 Hz (L)128 x (D)42 mm 262g (including battery )
OUTPUT & RUNTIME
*
TURBO (3200 1000 lumens)
*
HIGH (1500 1000 lumens)
MEDIUM (400 lumens )
LOW (60 lumens )
* Stated data on Turbo and High mode has been measured indoor under 25 degrees Celsius, windless
laboratory conditions. The data may vary due to environmental and heat dissipation conditions.
BATTERY INSTALLATION
Ensure battery is inserted with the positive (+) end pointing to the head. The
flashlight will not operate with incorrectly inserted battery.
SUPPORTED BATTERY
• 1 x 26650
CHARGING
For better user experience, please charge up the battery before use to ensure that
the battery has full power. For the battery provided with the package, according to
IATA lithium battery transportation regulations, the battery power allowed is under
30% of full capacity.
The flashlight comes with two chargers, which vary according to the different
versions.
The Standard version: Includes the portable USB charging cable. Connect one end
of the portable charging cable with the USB power source and place the other end
near the round charging port at the tail. It will be pulled to the tail cap automatically
through the magnetic force. The charging indicator glows red while the flashlight is
being charged, and glows green when the it is fully charged or on standby.
The Law Enforcement version: Includes the charging dock, which will supply power
in two ways:
IPX8 1.Connect to the wall socket through the included AC adapter.
2.Connect to the AUX input through the car charger.
When it is connected, the indicator on the charging dock will glow green. Place the
flashlight on the charging dock to begin charging the light. The indicator will glow red
while charging, and glow yellow while it is almost charged up. When the light is fully
charged, the indicator will show steady green.
1) Fix it to a vertical surface (wall or inside a car) with the screws or magic patch
screws(1)
1.5 mins+150 mins
10 mins+160 mins
7.5 hours
50 hours
(included)
screws(2)
magic patch(1) magic patch(2)
magic patch(3)
2) Place it on a horizontal surface (on top of a flat surface or a table)
EMERGENCY LAMP
The emergency lamp function will be active when the flashlight is placed on the
charging dock. This function can be turned on or off through the switch in the
charging dock. When using the emergency lamp function, make sure that the
flashlight switch is aligned with the front bulge of the charging dock. When the
external power is cut off, the flashlight will automatically light up at the low mode.
When the electricity is restored, the light will switch off in 10 seconds. The
emergency lamp function is unavailable if the light is being charged under the
lockout mode.