H-tronic HT3E Bedienungsanleitung Seite 21

The following modes are possible:
Transmitter button
„1"
„2"
„3"
„4"
noTE: "T" – tipped mode; "R" – switched mode
ExamplE: When you press transmitter button „2", you switch relay 1 to switched mode
and relay 2 and 3 to tipped mode. When pressing transmittor butten 4 you switch all
those 3 relays to switched mode.
3.4 DElETIng THE STaTIon mEmory lIST
A maximum of 32 transmitters can be programmed. If 32 stations have al-
ready been programmed into the receiver, no additional transmitters can be
programmed. Previously learnt codes are not lost. After deleting all transmitters,
new transmitters can be programmed again.
If the transmitter list needs to be cleared and reset, the deletion can be made
with the following steps:
1. Separate the receiver from the power supply.
2. Press and hold the button 1 "Learn".
3. Reconnect the device to the power supply.
4. The LED "Learn" will light up.
5. Wait till the LED starts blinking rapidly.
6. Release the button "Learn". All programmed transmitters are now deleted.
The receiver can now be programmed with new transmitters.
rEl1
T
R
R
R
rEl2
T
T
R
R
3-Channel Receiver HT3E
rEl3
T
T
T
R
| 21