Technical Data; Use; Maintenance And Care - Riwall Pro Rac 220 Originalbetriebsanleitung

Please note that our equipment has not been de-
signed for use in commercial, trade or industri-
al applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
Remaining hazards
The machine has been built using modern technology
and in accordance with recognized safety rules.
Some hazards, however, may still remain.
• Electrical hazards exist when unsuitable electric
connections are used.
• Although having regarded all considerable rules
there may still remain not obvious remaining haz-
rds.
• Minimize remaining hazards by following the in-
structions in "Safety Rules", "Use only as author-
ized" and in the entire operating manual.

7. Technical data

Input voltage
Mains frequency
Nominal power
Charging voltage
Charging current
Operating temperature
Protection class
Mass

8. Use

m CAUTION!
• Never charge batteries below 0 °C or above 40 °C.
• Do not charge batteries in environments with high
humidity or high temperatures.
• Do not cover the battery or the charger during
charging.
Charging
m CAUTION!
Insert original batteries only into the charger.
NOTE
During charging, the battery and the charger will heat
up. That is normal.
• Connect the mains plug with the socket (Fig. 1).
The red LED is on.
• Fully insert the battery into the charger.
The red LED is on and the green LED flashes, the
battery is charging.
• When the battery has been fully charged, the
green LED will come on.
• If both the red and green LEDs flash, a charge er-
ror has occurred. Check that the battery is insert-
ed correctly. If the error persists after re-inserting
the battery, the battery is defective and must be
replaced.
• A flashing red LED indicates that the charger is
Advice for a long battery service life
220-240 V~
Lithium-ion batteries do not have the known "memo-
50-60 Hz
ry effect". Nevertheless, a battery should be fully dis-
65 W
charged before charging it, and the charging process
should always be fully completed. If the batteries are
20,5 V
not used for a while, store them partly charged in a
2,4 A
cool place (10-25 °C).
0 - 40 °C
II
NOTE: Reduced operating durations after charg-
ing indicate a worn battery. The battery must be re-
0,35 kg
placed.

9. Maintenance and Care

m WARNING! Disconnect the mains plug before all
work. Do not use water or liquid detergents.
Cleaning
• Remove dirt and dust from the casing using a brush
Storage
• Store the device in a dry and frost-free (10-25 °C)
• Store the battery and the device separately from
There are no parts inside the equipment which re-
quire additional maintenance.
Connections and repairs
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Machine data - type plate
operated outside the recommended operating tem-
perature range (0°C-40°C). The battery cannot be
charged if the temperature is too loo or too high.
Red Green
Battery charge level
LED LED
●
Charger is connected to
main power
● ☼
Connected battery is charg-
ing
●
Connected battery is fully
charged
Connected battery has a
☼ ☼
charging fault
Charger is outside corredt
operating temperature
☼
(<0°C / >40°C)
or a dry cloth.
place.
each other.
GB 13