How To Use The Remote Control; Switch On/Switch Off - Kindermann TD-10552-S Bedienungsanleitung

5.2 How to use the remote control

• Point the remote control at the receiver. Objects located between the remote control
and the radio receiver may interfere with its operation.
• If the radio receiver is exposed to direct sunlight or strong light, the remote control
may malfunction. In this case, change the angle of the lighting or product or use the
remote control closer to the radio receiver.
• Replace the batteries when they are weak as this will reduce the range of the remote control.
If the remote control is not used for an extended period of time or the batteries are empty,
remove the batteries as leaking liquid from the batteries may damage the remote control.
• Do not use diff erent types of batteries and do not use new batteries with existing ones.
Always replace batteries in pairs.
• Do not throw batteries into a fi re, charge them, or disassemble them. Used batteries must not
be charged, short-circuited, disassembled/assembled, heated or burnt.
• Please dispose of empty batteries in accordance with the relevant environmental regulations.
6. Switch on/switch off
• Power the display. The power switch is located on the bottom of the display.
• The power button on the remote control and on the front panel
8
can be used to switch the display on or off .
Please note:
A short push on the front panel switches the display dark.
To switch it to standby mode, press and hold the key for at least 2 seconds.
• Save before switching off
Before switching off , the display saves the picture and sound settings.
These settings are used during a restart.
• OPS PC ON/OFF
If the display is equipped with an OPS PC and this is selected as the signal source,
the OPS module starts automatically.
Please shut down the OPS computer properly before switching the display
into standby mode or off . This can cause damage to the OPS computer
or the installed software.
To switch off the product, the standby button on the panel or remote control
can only be used after the OPS module has been completely shut down.
Please note:
The OPS PC can be purchased optionally.
34