Technical Data; Proper Use; Safety Information - HERKULES HSA 120 Bedienungsanleitung

Anl. HSA 120 03.03.2005
1. Layout (Fig. 1 - 3)
11. Cotter pin Ø 3 x 30
12. Hexagon nut M12
13. Spring washer Ø 12
14. Washer Ø 12
15. Hinge pin, large
16. Hexagon bolt M 12 x 60
17. Pipe collar for support arm
18. Cotter pin Ø 3 x 45
19. Pipe collar for rectangular boom
10. Support arm
11. Rectangular boom 45 x 45 x 1.8
12. Hexagon bolt M 12 x 70
13. Pads for clamping brackets
14. Hexagon nut M8
15. Spring washer Ø 8
16. Washer Ø 8
17. Extension pipe 40 x 40 x 2.5
18. Hexagon bolt M8 x 15
19. Hinge pin, small

2. Proper use

The SA 1200 swing arm is designed to take a cable
winch. For this, the swing arm must be mounted to a
securely fastened steel bar with a diameter of 48
mm. The swing arm may only be used for the tasks it
is designed to handle.
Any other use than that which is considered proper is
deemed to be a case of mis-use. The user/operator
and not the manufacturer will be held liable for
damage and/or injuries of any kind that result from
such behavior.

3. Safety information

Please read the directions for use carefully and
observe the information provided. It is important to
consult these directions in order to acquaint yourself
with the tool, its proper use and the safety
information.
Ensure that you observe the following points in order
to avoid accidents and injuries.
Do not overload your swing arm.
Do not continue to use the swing arm if it is
damaged.
Ensure that all bolts are tightly fastened and check
them frequently for your own safety. Ensure that the
13:31 Uhr Seite 5
cotter pin is properly inserted through the bore holes.
Lifting and carrying persons with the cable winch is
strictly prohibited! Additionally, persons may not loiter
underneath the cable winch/swing arm assembly.
Persons who are not aware of these safety
precautions may not use this product.
All components must be regularly checked for any
kind of deformation or damage.
Observe the maximum permissible load capacity
(see „Technical Data")!

4. Technical data:

Reach l: Max. load:
750 mm 600 kg
1,100 mm 300 kg
Swing range: max. 180°
5. Mounting and assembly
The swing arm is designed to take a cable winch.
To mount the swing arm, you need a round steel bar
with a diameter of Ø 48 mm; its wall must be a
minimum of 3 mm thick. Ensure that the anchor
points of the steel bar are able to adequately support
the forces that will be applied to it. Consult an
authorized professional to ensure that this is properly
done. Attach pipe collar (9) (with large hinge pin (5))
to the steel bar using the two hexagon bolts (6),
washers (4), spring washers (3) and two hexagon
nuts (2).
Before you tighten the bolts, push the pipe collar (9)
to the desired work height of the swing arm. Apply
lubricating grease to the hinge pin (5).
Slide the rectangular boom (11) over the hinge pin
(5) and push the cotter pin (8) through the hole in the
hinge pin. Finally, bend both shanks apart from each
GB
Kg 300
5