URBANGLIDE MOTO CROSS 2.0 Bedienungsanleitung Seite 11

Problem
The motorcycle does
not work
The motorcycle does
not work long
The motorcycle
suddenly stopped
working
The motorcycle makes
strange noises when
the engine is running
The motorcycle is
moving slowly
The motorcycle runs
from time to time and
then does not work
The charger heats up
during use
The bike does not
stop when I brake
TROUBLESHOOTING
Possible cause
The battery is not charged.
Connections or cables are disconnected.
The battery needs to be charged.
The battery does not charge fully.
The brakes are not properly adjusted
Tires are not properly inflated
Overload, cut-off
Grilled fuse
The chain is struggling to work
The brakes are not properly adjusted
The bike has overloaded
Bad driving condition
Tires are not properly inflated
Connector and cable issues
The engine or electronics has a problem
Normal action of the charger
The brakes are not well adjusted
Solution
Charge the battery, 12h may be necessary.
Check that the battery is firmly engaged in the
motorcycle.
Make sure your wall outlet is working.
A short circuit may have occurred, check the
condition of the fuses.
Charge the battery, 12h may be necessary.
Check that the battery is firmly engaged in the
motorcycle.
Make sure the power flow is well connected.
The battery may need to be changed.
Check the condition of your brakes
Check the condition of your tires.
Overloading can lead to system shutdown. Turn
off the bike, wait 15 seconds, then turn it on
again.
Overloading can burn fuses, so you have to
change them. For this, contact the after-sales
service.
Check before the status of all connectors and
cables.
Apply lubricant to the chain.
Follow the instructions on page 8.
Make sure the person on it weighs less than 68kg.
Check that there are no objects obstructing the
proper operation of the vehicle.
Make sure you are on flat, dry, and constant
ground.
Follow the instructions on page 6.
Check the condition of your motorcycle's cables.
Contact your local after-sales service.
No problem if your charger heats up during
charging, it's a sign that it is working properly.
Follow the instructions in the manual p8
11