Problems And Solutions - VES VIP-009-B Bedienungsanleitung

CLEANING
Unplug the appliance from mains. Detach water tank. Pour water
remnants out of water tank. Rinse water tank with clean water, let
dry. Wipe the base with wet cloth. Install water tank back
base. Roll power cord carefully. For appliance cleaning use only
the clean water or neutral cleancers. Do not use the caustic or
abrasive cleancers (e.g. vinegar or decalcifiying agents) as they
may damanage the appliance. Do not wash the tips with water
hotter than 40°C.
- If you used the mouth wash its remnants must be cleaned
away. For this clean the tank with clean water, pour the filtered
clean water in the tank and drain through the used tip by
switching the appliance on.
- Appliance desinfection. Pour 200-300 ml of 40 % medical
alcohol solution into the tank and drain it through the tips by
switching the appliance on. One hour later, rinse the tank with
clean water, pour the filtered clean water in the tank and drain
it through the tips.
Storage
Keep the unit assembled in a clean, dry place, away from
children.
When transporting and storing the device, observe the following
rules:
- The unit must be empty and completely dry.
- After transportation of device at low temperatures must be left
in the room for at least 2 hours before using.

Problems and solutions

Possible
Problem
reason
Leakage between Tip
the tip and the installation.
t i p rot at ing
mechanism.
onto the
Solution
incorrect Eject the tip and
install correctly.
8
Leackage of Tip if torn.
periodontal tooth
pocket tip end.
Leackage of hose. Hose is torn.
Leackage of water Incorrect
installation of
tank.
the water tank
or there is no
rubber plug.
Rubber
plug placed
incorrectly.
Low water pressure Water tank
or there is no water is incorrectly
coming. placed on the
base. There
is no water in
tank.
The appliance is Motor is not
switched on. working.
Tips and tank are There may be
correctly installed. the airlock in
There is water in the device.
tank but the water
is not running.
PRECAUTIONS
Use only the filtered water! Tap water contains salt,
sand, lime, etc., which will clog the appliance. The
Change the tip.
Change the hose
at service center.
Install the water
tank correctly.
Isntall the rubber
plug back. If plug
lost, address to
service center.
Install the rubber
plug correctly.
Place water tank
well.
Fill tank with water.
Make sure there is
current in net.
To eliminate the
airplug turn the
unit on and gently
retract the air
from a tip without
swallowing suddenly
entered the water.
9