Go/on SFT-ENP Bedienungsanleitung Seite 7

EN
OPERATING INSTRUCTION
CAUTION: Do not keep the keys in the safe itself.
1.OPENING THE SAFE FOR THE FIRST TIME
To open the safe for the first time, remove the small central cover "Z" (see Fig. 2)
between knob and keypad, insert the key into the lock and turn it counter-clock-
wise, at the same time, turn the doorknob clockwise and open the door.
2.INSTALLING THE BATTERIES
The safe requires 4 x size "AA"(1.5V) batteries.
The batteries compartment "Y" (see Fig. 1) is located on the back of the door.
Remove the battery cover and install the batteries into the compartment. Ensure
the batteries are fitted with the correct corresponding polarity.
Once the batteries are installed, close the battery compartment.
3.PROGRAMMING THE CODE
a. Remove the battery cover and press the red button "X" inside the battery
compartment (see Fig. 1), release it and you will hear two beeps.
b. Now press from 3 to 8 numbers that you wish to use as a combination, and
confirm by pressing the letter "A" or "B" within 15 seconds.
c. Write down your new combination immediately and check whether your new
combination has been programmed or not on conditions of the safe door open.
4.USING YOUR SAFE
To open the safe, enter your personal code and confirm by pressing the letter "A"
or "B". You will hear a beep and the green light will be on, then open the door using
the knob within 5 seconds.
If you or an intruder uses the incorrect group of numbers, it will not open. If the
incorrect combination is used 3 times consecutively, you must wait for 20
seconds before reattempting. If again the incorrect combination is selected 3
times, you must wait approximately 5 minutes before reattempting access.
5.BATTERY REPLACEMENT WARNING
If the batteries are low, the red light (on the left) will warn you immediately. To test
the batteries, just input your personal numbers to open the door. If the batteries
are low, the red light will be on. If nothing happens, it means that the batteries are
in order.
-10-
6.REPLACING THE BATTERIES
The safe requires 4×size "AA" (1.5V) batteries. Open the safe, remove the battery
cover plate "Y" (see Fig. 1) on the back of the door and replace the 4 old batteries.
You must reprogram the code, using the above steps.
Use of alkaline batteries is recommended.
7.OVERRIDE INSTRUCTION TO OPEN THE SAFE
For your convenience, we have engineered a manual override system for your safe.
If you forget or misplace your combination, remove the small central cover "Z
"(see Fig. 2) between knob and keypad, insert the key into the keyhole and turn it in
a counter-clockwise direction, then turn the knob in a clockwise direction towards
the right. This will manually open your safe at any time.
8.INSTALLING THE SAFE
To reduce the risk of theft of the safe, it can be secured to floor, wall or in a
cupboard. For your convenience, there are holes (diameter 8mm) both in the
bottom and on the back; therefore it can be fixed by the expansion bolts supplied.
CAUTION:
The safe should be placed horizontally when installing the safe.
-
Y X
Fig. 1
-11-
Z