SHE SHE40ST2002SMF Bedienungsanleitung Seite 20

Filling the Watertank
1. Open the cover of the
water tank at the rear of the
housing.
4. Unscrew the cap and fill the tank with pure, cold water.
Then schrew it counterclockwise and turn it over again, so
the shutter is facing down. Make sure that no water drips
out. If water drips out, please tighten the screw.
Set the functions
Turn the device ON/OFF
To turn the device on/off please use the button.
The last settings used are retained for the new commissioning.
Setting the Speed
You can choose between three speed levels:

Press 1x  Level 1 (low power)

Press 2x  Level 2 (medium power)

Press 3x  Level 3 (high power)
On the remote control you can control the speed with the + and – buttons.
2. Lift the water tank and
remove it.
Seite 20 von 26
3. Turn the tank around so
that the shutter is facing up.
5. Carefully insert the water
tank into the housing and
close the cover.