Assembly - She She40St2002Smf Bedienungsanleitung

1. Place the standbase (19) on a flat surface and insert the housing (17) into the base.
Please pay attention to the bulges of the housing and the recesses of the standbase
 First insert the housing into the front of the standbase and then push it inwards to
lock it in place.
2. Loosen the fixing screw (12) and insert the standpipe with the fan head (11), from
which the cable leads into the housing, into the opening. Press the standpipe into the
opening until the hole on the standpipe reaches the fixing screw. Now screw them
tight.
3. Now carefully place the device horizontally on the floor to connect the housing (17) to
the standbase (19). To do this, screw the mounting screw of the housing (20) firmly to
the thread of the fan housing (18), so that the device is stable.
4. Now attach the castor wheels (21) to the base by inserting them into the notches
provided for this purpose. You can now set up the device again.
Installation of protective grille and fog plate
1. Remove the fixing ring (5) and the threaded nut (7) by turning them off the motor shaft
(9).
2. Place the rear guard (8) on the motor housing by sliding it over the motor shaft (9).
Now screw on the threaded nut (7) again to fix the rear grille.
3. Slide the fan blades (6) over the motor shaft (9) so that their notches and locating
pins engage.
4. Secure the fan blades (6) by installing and tightening the mounting ring (5)
(ATTENTION: left-hand thread - turn to the left to tighten the screw).
5. Then check the correctness of the assembly by turning the blades by hand  the
blades and the nut must not touch each other.
6. Now install the front guard (2), the guard ring (3) and the fog plate (1) as follows:
a. Remove the screw (4) from the guard ring (3) and open the clamp (4).
b. The guard ring (3) has two inner guide rails - insert the front guard (2) into the
required guide rails (the rear guard is later inserted into the other guide rail).
c. Now place the fog plate (1) with the hose (14) on the center of the front grille
(2) and tighten it so that the hose is in line with the bracket (4) and points
straight to the bottom (because the Clip must be below).
d. Turn the front guard (2) over and tighten the plate (1) with the three screws
provided.
e. Then insert the front guard (2) prepared with the guard ring and fog plate onto
the rear grille (8), making sure it snaps into the rear guide rail.
7. Now insert the other end of the hose (14) over the hose connector (13) on the fan
housing (17) while squeezing the metal clamp (15). After the tubing is properly
attached, release the metal clip (15) at the end of the tubing, securing the tubing.

ASSEMBLY

Seite 18 von 26