Technical Data - Redstone HM120L Original Bedienungsanleitung

6. Technical data

AC motor
Power
Operating mode
Idle speed
Carbide saw blade
Number of teeth
Swivel range
Mitre cut
Saw width at 90°
Saw width at 45°
Saw width at 2 x 45°
(double mitre cut)
Protection class
Weight (incl. accessories)
Laser class
Wavelength of laser
Laser output
* S6 25%, continuous operation periodic duty.
Identical duty cycles with a period at load fol-
lowed by a period at no load. Running time 10
minutes; duty cycle is 25% of the running time.
The work piece must have a minimum height of
3 mm and a minimum width of 10 mm.
Make sure that the workpiece is always secured
with the clamping device.
Noise and vibration
Total vibration values determined in accordance with
EN 62841.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Wear hearing protection.
The effects of noise can cause a loss of hearing.
Total vibration values (vector sum - three directions)
determined in accordance with EN 62841.
Vibration emission value a
h
Uncertainty K
230 V~ 50Hz
2000 Watt
S6 25%*
4200 min
-1
ø 305 x ø 30 x 3,0 mm
60
-45° / 0°/ +45°
0°−45° left / right
340 x 90 mm
240 x 90 mm
240 x 55 mm
II
23,0 kg
2
650 nm
< 1 mW
99,9 dB(A)
3 dB
112,9 dB(A)
3 dB
2,091 m/s²
1,5 m/s²
The specified vibration value was established in ac-
cordance with a standardized testing method. It may
change according to how the electric equipment is
used and may exceed the specified value in excep-
tional circumstances;
The specified vibration value can be used to com-
pare the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Attention!
The indicated weighted effective value of accelera-
tion can differ during operation from the indicated
value, dependent on the manner in which the device
is used. Dependent upon the actual conditions of
use (periodic duty) it may be necessary to establish
safety precautions for the protection of the operator.
Residual risks
The machine has been built according to the
state of the art and the recognised technical
safety requirements.
However, individual residual risks can arise dur-
ing operation.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the „safety in-
structions" and the „Proper use" are observed
along with the whole of the operating instructions.
• Do not load the machine unnecessarily: excessive
pressure when sawing will quickly damage the saw
blade, which results in reduced output of the ma-
chine in the processing and in cut precision.
• When cutting plastic material, please always use
clamps: the parts which should be cut must always
be fixed between the clamps.
• Avoid accidental starting of the machine: the op-
erating button may not be pressed when inserting
the plug in an outlet.
• Use the tool that is recommended in this manual.
In doing so, your mitre saw provides optimal per-
formance.
• Hands may never enter the processing zone when
the machine is in operation. Release the handle
button and switch off the machine prior to any op-
erations.
GB | 27