Suntec Wellness FDH-8595 Bedienungsanleitung Seite 10

Components
Operation
•
Operating voltage: 220-240V~, 50/60Hz, 200-240W
•
Before first usage:
Please remove all packaging materials and clean all trays and inlay mats in accordance with
o
the section "Cleaning". Place the inlay mats on the trays and stack the trays on top of each
other as shown in the section "Components". Please connect the appliance to the power supply.
When the appliance is used for the first time, it must be put into operation for 30 minutes without
o
any content. Possible smoke or odour development due to production-related residues are
normal during this time. Please ensure adequate ventilation. When the time is over, the trays
and inlay mats must be cleaned again. To do so, please remove the appliance from the power
supply (see section "Cleaning").
•
Preparation:
Please prepare the food to be dried. Fruit, vegetables, herbs, nuts, bread, meat or fish are
o
suitable for the drying process. For vegetables and fruit it is recommended to cut them into thin
slices.
Spread your prepared food on the trays while starting with the lowest one. Make sure that there
o
is space between two slices of food. Do not overfill the trays. Please always use at least three
trays to ensure the functionality of the appliance.
The fine-meshed inlay mats can be used for particularly fine or small foods. If required, the
o
height of the trays can be adjusted as well. For bigger food, arrange the trays in a way that the
clips of two trays are positioned directly on top of each other, as shown in the following picture:
As soon as you have finished the preparation, close the uppermost tray with the lid.
o
•
Drying process:
Control panel:
o
5
Please connect the appliance to the power supply. An acoustic signal sounds.
o
Switch the appliance on by using the on/off button. Every operation on the control panel is
o
accompanied acoustically. The display shows the default setting "10.00" which indicates a
drying time of 10 hours. As soon as the dot between the hours and minutes flashes, the drying
process begins. Due to the built-in fan, warm air is circulated evenly over all floors, drying your
food.
Use the timer setting button on the control panel to adjust the drying time between "00.30"
o
Timer setting
Lid
5 Trays
2 Inlay mats
Base
Control panel with LED display
Temperature setting
On/Off