Zander Aachen MVisio HMI Lite Kurz- Betriebsanleitung Seite 7

Quick Start Guide MVisio HMI Lite
Quick Start Guide
Assembly
Connect
Connect the device according to the figure.
Voltage supply Connect the device to the supply voltage according to the illustrations.
Danger
Wrong choice of power supply
Danger to life due to overvoltage
and electric shock
Only operate devices at SELV-power supplies

Tel +49 241 9105010 • Fax +49 241 91050138 • info@zander-aachen.de • www.zander-aachen.de
H. ZANDER GmbH & Co. KG • Am Gut Wolf 15 • 52070 Aachen • Germany
A = MVisio Pro, B = Panel cut-out
Mount the device as follows:
Tighten each of the screws until the corners of the frame

rest on the panel. The maximum tightening torque
is 0.75 Nm.
Select a mounting location so that the device is not exposed

to direct sunlight.
Do not cover the ventilation slits in the device.

Connection/ Slot Function
1 Voltage supply
2 (X2)
RS422/485 + CAN (COM2/CAN0)
3 (X3) RS422/485 + CAN (COM3/CAN0)
4 (X4) RS232 + RS 232 (COM1/COM4)
5 (X5) USB-Port
6 (X6) USB-Port
7 (X7) Ethernet-Port 0 (10/100/1000 MBit)
8 (X8) Ethernet-Port 1 (10/100 MBit)
9 (S1) RS485 + CAN Port-Configuration (DIP)
10 (S2) RS485 + CAN Port-Configuration (DIP)
Note
Devices of protection class
EN 61140 or class 2 to UL standard:
All connections are SELV connections.
English Translation
Errors and technical changes reserved
III to
M08
E61-455-00
7