Technical Data; Maintenance - weinor BiSens SW-Solar Originalmontageanleitung

Technical data

Power supply
Temperature range
Detection angle (light sensor)
Protection class
Radio frequency
BiSens SW-Solar power reserve
For the USA, Canada, Australia and some nations in South America
the following applies:
Radio frequency: 915 MHz frequency band

Maintenance

The BiSens SW-Solar must be freely accessible and must not be
overgrown by vegetation.
The BiSens SW-Solar is maintenance-free. However the cover
must be cleaned from time to time using a damp cloth.
weinor Mathias-BrüggenStr. 110
GmbH & Co. KG D-50829 Köln
Solar
-25 °C to +60 °C
150 °
IP 43
868 MHz frequency band
≥ 12 hours
Fon: +49 221 5 97 09-211
Fax: +49 221 5 97 09-898
Fault Cause
• Awning is • Wind alarm
automatically
retracted in the
manual mode
• Poor radio connection
• The travel com- • Wind alarm is active
mands can not • Battery in the hand-
be sent using held transmitter is
the hand-held discharched
transmitter • Motor has no power
supply or is over-
heated
• Awning is not • Wind threshold value
retracted in is set incorrectly
windy conditions • Wind vane is dam-
aged
• Awning is not • Threshold set incor-
extended in rectly
sunny condi- • Wind alarm is still
tions active
• Manual mode is set
• Poor radio connection
• Light sensor is dirty
• Light threshold value
(OFF setting)
• Receiver does • BiSens SW-Solar
not accept new has already been
BiSens SW- programmed
Solar
info@weinor.de
www.weinor.de
Remedy
• Wait until the wind
alarm lock-out is de-
activated (15 minutes)
or briefl y interrupt
power supply.
• Change the
position of the
BiSens SW-Solar
• Wait (15 minutes)
• Change battery
• Check power supply
and allow the motor to
cool down
• Set correct value
• Replace
• Set correct value
• Wait
• Set automatic mode
• Change the position
of the BiSens SW-
Solar
• Clean light sensor
• Set appropriate level
• Delete the BiSens
SW-Solar
Technical parameters subject to change